ALU neighbourCellPrio in WIPS

[scientist]

Dear All,
I have missing neighbors in my network which I have declared.
In Alcatel you have to set the order of the NEIGHBORCELLPRIORITY.

I have some some FDDcell to UMTSFddNeighbouringCell with unset neighbourCellPrio.
Please I need help how to set them.
See picture.

[Boraa]

Send the snapshot on boraa_89@hotmail.com

[bawbag11]

Normally WIPS will not allow neighbour without priority set. The priority is used in soft handover when neighbour list concatenation happens and you get the highest priority ones sent in the measurement control message.

In WIPS just filter on the source FDDCell then pick a priority not already used for the missing one. Easier just to copy and paste existing neighbour and amend the details rather than use the wizard tool.

BB

[scientist]

Normally WIPS will not allow neighbour without priority set. The priority is used in soft handover when neighbour list concatenation happens and you get the highest priority ones sent in the measurement control message.

In WIPS just filter on the source FDDCell then pick a priority not already used for the missing one. Easier just to copy and paste existing neighbour and amend the details rather than use the wizard tool.

BB
@hello Bawbag, thank you very much.Please can you amend the changes inside or only on the excel sheet.
How do I compare two snapshot, if you have any documents on wips place send me.
Documents to make life easier.
Kr
Scientist

[alchi]

This would really help if you can send related documents if anyone has it. Neighbor relation optimization in ALU documents are also welcomed. Thank you...