Map info tool to plot cells & modify value

[itking]

Hi Experts,

I am relatively new to Map Info, I need two map info tools/way [or either 1 tool to do both] to"

1. Plot the cells as lines only [as highlighted in attached snap]
2. once I need info it should show all value of specific Cell i.e. azimuth, LAC etc but in the same time if i modify any of them it should be updated on map layer & in table.

Waiting for your opinion


36911

[captain_jejemon]

Hi Friend,you can use simple tool like SiteSee

[captain_jejemon]

link: http://www.finetopix.com/showthread.php?32882-Need-SiteSee&highlight=sitesee

[itking]

Hi Friend,you can use simple tool like SiteSee

No Site See plotting sites with specific beam width, plus cell value modification isn't possible

[peanut]

Piano tool will be you best choice, Look @: http://www.finetopix.com/showthread.php?6946-Piano-tool#4

regards,

[itking]

Piano tool will be you best choice, Look @: http://www.finetopix.com/showthread.php?6946-Piano-tool#4

regards,

This is what I was looking for........ Thanks

[itking]

Piano tool will be you best choice, Look @: http://www.finetopix.com/showthread.php?6946-Piano-tool#4

regards,

One more question............ I've on Air & off air sites,,,,,,, can we give different colors accordingly?

[Shakeel_15]

Hello,

Use thematic map provision of mapinfo.

BR


One more question............ I've on Air & off air sites,,,,,,, can we give different colors accordingly?

[itking]

Thanks Guys,,,,, it was really helpful.....

If I want to add one more new site/cell later on in map info tabl file ............ what could be the fastest way to do this?

[peanut]

Dear,

You need to rebuild Tables from scratch if you wanna add a new site later

Best regards,

[itking]

Dear,

You need to rebuild Tables from scratch if you wanna add a new site later

Best regards,

now this is bad .......... In a roll out project its quite time taking