Noise Rise Counters in Huawei

[RF Engr]

Dear Friends
Kindly help that which counters are used in huawei to check noise rise?
Thanks in advance

[baby2]

Dear Friends
Kindly help that which counters are used in huawei to check noise rise?
Thanks in advance

Search RTWP.mean
nomal value is -106 dBm (no load)

if noise rise 50% ,it will be -103 dBm

[samuraial]

That depend of the ROT you have configured for that cell.
IF it is 75% as default configuration you are going to have 6dBm rise in noise when the Ul load reach that value.
If you configure the ROT to 90% as far as I remember the rise went up to 10dBm if I am not wrong.

B/R

[baby2]

That depend of the ROT you have configured for that cell.
IF it is 75% as default configuration you are going to have 6dBm rise in noise when the Ul load reach that value.
If you configure the ROT to 90% as far as I remember the rise went up to 10dBm if I am not wrong.

B/R

Yep 10 x log(75%) = 6 dB

If talking about Huawei product ,in no load and interference UL will be -106 dBm
So if 75% ,it will be -106 dBm + 6 dB ,so = -100 dBm.

[hieuphong]

Dear Friends
Kindly help that which counters are used in huawei to check noise rise?
Thanks in advance
You can use "VS.EcNo.Mean.TPx" and show on the chart
Very simple

[peanut]

What does it mean ROT?

BR


That depend of the ROT you have configured for that cell.
IF it is 75% as default configuration you are going to have 6dBm rise in noise when the Ul load reach that value.
If you configure the ROT to 90% as far as I remember the rise went up to 10dBm if I am not wrong.

B/R

[samuraial]

Rise over thermal :)

B/R

[peanut]

Thanks for reply,

Could we configure ROT? witch command? RNC Level or NodeB?

BR


Rise over thermal :)

B/R

[samuraial]

It is cell level my friend,

LST UCELLHSUPA
Maximum Target Uplink Load Factor = 75.
It is Huawei default value.

In order to increase it you need to change it on CAC also.
LST UCELLCAC(disable UL Algorithm in UCELLALGOSWITCH, or increase the UL total power threshold from 83 to 90 as it wont allow you to increase Maximum Target Uplink Load Factor).

But don't pass 90% value as the cell coverage will shrink and you could experience CDR on the edge of the cell :)
Also check for RTWP also in your trial.

B/R

[RF Engr]

Background Noise parameter value change also helps to counter RTWP.


It is cell level my friend,

LST UCELLHSUPA
Maximum Target Uplink Load Factor = 75.
It is Huawei default value.

In order to increase it you need to change it on CAC also.
LST UCELLCAC(disable UL Algorithm in UCELLALGOSWITCH, or increase the UL total power threshold from 83 to 90 as it wont allow you to increase Maximum Target Uplink Load Factor).

But don't pass 90% value as the cell coverage will shrink and you could experience CDR on the edge of the cell :)
Also check for RTWP also in your trial.

B/R