Mtp850 Usb Driver

[battabatta3]

i need a Usb driver to my ******** MTP850

[kondoros]

There is not any special MTP850 driver.

If you want to program/reprogram your terminal you follow some simple steps :

1. Install and run the CPS
2. Remove battery from the terminal
3. Put back the battery to the terminal
4. Connect the programming cable to the bottom of the terminal
5. Keep pressed keys [1] +[9] and power on (At this point the terminal's display remains off)
6. Connect the USB side of the programming cable to your PC
7. Windows PC recognizes and installs terminal and terminal's display after few seconds starts to flash
8. Then you go back to the CPS and you do what you want to do

If something goes wrong we are here to help you.

[battabatta3]

thanks for the help. Then, just next problem. my radio has a kidney version. relative to the minimum cps. have something lying in'll share with me. so is nice

my cps version. R6c_417_01
my mtp version. R13.020.7184

[kondoros]

Dear battabatta,
I don't understand your request or problem.
From your firmware version R13.020.7184 I understand that your terminal has TEA2 algorithm installed and that your CPS is outdated (it is about 7 years old).
Please be more specific.

[battabatta3]

I need a newer update of tetra cps. I can not read out my radio. because it is an old cps.