MTP700 questions

[RA1AIE]

Hi all.

Please help me with programming ******** terminal MTP700.

I have this terminal, hand-made RS232 interface and Carrier CPS MR3.1.6. I want to program TMO mode for scanning local TETRA network, and I know MCC, MNC, some frequencies, group IDs and correct terminal IDs of network (this information given by osmocom software).

What i should set into Frequency List 1-4? Frequencies of base stations? Simply freq range? Or what?
How i can scan groups from this terminal?
Can i program multiple networks in TMO mode or not?
Can i program out-of-band frequencies (this is 380-430 version, and i want program 430-440 HAM band for use in DMO mode).

Thanks.

P.S. I am novice in TETRA, and sorry for my bad English.

[sacha_1980]

You may just set the network frequency and number of channels in the Frequency list # 3, it will work fine (along wth correct mcc, mnc, issi & talkgroup id of course!)

[nintrew]

you can increase the frequency range with cps plus depot version or you send me a link to your codeplug-file in a pm an i'll do it for you!

[motorolatrbo]

Going above 435mhz will decrease the sensitivity of your radio.

[Digitalmotorola]

you can increase the frequency range with cps plus depot version or you send me a link to your codeplug-file in a pm an i'll do it for you!
Hi,
I also want to extend freq. range of my MTP700 to 435MHz.. Will you do that for me?? Codeplug I can send, its cpg version 4409.
Many thanks