Ceragon IP-10Q initial configuration

[rbaranowski]

Hi,

I'm new on that forum.
We just got 3 unit of Ceragon IP-10Q to establish XPIC link between them.

Not tricky part for me, how to get management access to them?
Management port LED is dark, no link on any ethernet interface on that.

Any thoughts how to gain access?

Regards

[Cost_Reducer]

have you powered up the unit ? :-)
try using the serial interface, should give you always access to the system

[rbaranowski]

Power was connected.
I got documentation - unit have to be putted in proper slot to get management access.
Left, lower bay is master for whole unit. Next one is on right hand side from Master unit.

I have found manual for that if someone needs that.