View Full Version : Detected Intra/Inter Freq/IRAT NBRs - Huawei R14
khurrambilal01
2014-03-27, 04:52 PM
Hi Experts,
On RNC level we have separate switch for detection of Intra, Inter and IRAT NBRs which can be seen/changed by command : LST UAUTONCELLDETECT
Does anyone know if we enable this switch how can we add missing Intra/Inter Freq and IRAT NBRs? Or from which counters we can see which cells are missing after switching on this switch?
Any idea!?
Kitachi
2014-04-09, 02:16 PM
good job.
This is topo in SON . Does anyone know it ?, Please share .....
g.kashi@yahoo.com
2014-09-23, 08:44 PM
Good day
http://www.sendspace.com/file/qanmq1
Kitachi
2015-04-06, 11:56 AM
Hi, Everyone
Do you know it ? Enable or Disable
Vladislav
2015-04-19, 07:12 PM
Hi Experts,
On RNC level we have separate switch for detection of Intra, Inter and IRAT NBRs which can be seen/changed by command : LST UAUTONCELLDETECT
Does anyone know if we enable this switch how can we add missing Intra/Inter Freq and IRAT NBRs? Or from which counters we can see which cells are missing after switching on this switch?
Any idea!?
Hi!
As I know this is for Nastar iManager.
From Hedex "When this switch is turned on, missing intra-frequency(same for intrer-freq and inter-RAT) neighboring cell detection is enabled. A UE can report both detected set cells and monitored set cells to the RNC, which then reports the missing intra-frequency neighboring cells to the Nastar or LMT."
Hope this is helpful.
Best regards!
vBulletin® v4.2.5, Copyright ©2000-2024, Jelsoft Enterprises Ltd.