Error returned from NE: Command can not operate because flow control

[JO2GE]

I have this error when I perform CELL PERFORMANCE MONITORING in Huawei BSC6900 LMT

Error returned from NE: Command can not operate because flow control

Someone can have me a solution

Thanks in advance

[ivanbrij]

Dear Jorge,

You cannot perform the task because of flow control. It means than XPU CPU Load is high at that time.

Solution: perform the task at time when the XPU CPU Load is lower than 50%. Maybe at mid night or early in the morning. Below the Flow Control thresholds for XPU:

Board Class = XPU
Filter window = 10
Fast judgement window = 4
Critical threshold = 95
Print control threshold = 60
Print restore threshold = 50
Debug tracking control threshold = 60
Debug tracking restore threshold = 50
Performance monitor control threshold = 60
Performance monitor restore threshold = 50
Resource Audit control threshold = 85
Resource Audit restore threshold = 70
SMS page control threshold = 70
SMS page restore threshold = 60
SS and LCS page control threshold = 80
SS and LCS page restore threshold = 70
Call page control threshold = 90
Call page restore threshold = 75
Handover control threshold = 95
Handover restore threshold = 85
Iur uplink transfer control threshold = 95
Iur uplink transfer restore threshold = 85
Iur downlink transfer control threshold = 95
Iur downlink transfer restore threshold = 85
CBS control threshold = 85
CBS restore threshold = 70
Log control threshold = 90
Log restore threshold = 80
Cell URA update control threshold = 95
Cell URA update restore threshold = 80
Current XPU CPU share out threshold = 60
Offset of current CPU load and target CPU load = 5
AC control threshold = 80
AC restore threshold = 70
Iur-g control threshold = 60
Iur-g restore threshold = 50
Low Priority Service Control Threshold = 70
Low Priority Service Restore Threshold = 60
Normal Priority Service Control Threshold = 85
Normal Priority Service Restore Threshold = 75
High Priority Service Control Threshold = 90
High Priority Service Restore Threshold = 85


Please add REP

BR,

Ivan

[jorrgivarius]

How can I see my XPU CPU Load? and how I cand reduce XPU CPU load? I have delete tasks? How I do it?

[rfsupp]

Guys,

Actually you can disable the Flow Control - Trace: SET UFCW (Debug - Off).
Remeber that the Flow COntrol is still enabled, just for the trace functionality will be disable for a while. After finish you can activate again.