View Full Version : Question about Moshell or AMOS commands for eNodeB
dadoba
2013-05-10, 11:30 AM
Does anybody already have some commands to use in Moshell or AMOS to get or set some eNodeB parameters? I mean commands to perform some troubleshooting, configure and check some important parameters and features and check peformance?
Thank you in advance.
scumbie
2013-07-17, 12:51 PM
see if this helps.
Regards,
scumbie
badrinath888
2013-07-17, 07:15 PM
Thank you scumble, it's good stuff for an RF Engineer. Please share advance command level in the similar way that can be used by RF Expert (swamy888@gmail.com)
vBulletin® v4.2.5, Copyright ©2000-2024, Jelsoft Enterprises Ltd.