Low RSSI

[mpaizal]

Hi Friends,

Can someone advise on low RSSI problem, even VSWR is within good reading,

Thanks,

[bouciakt]

usually,,low RSSI caused by hardware (feeder, connector, jumper or related modul)
so maybe you can check each item first.

[MINTO]

2 reasons for LOW RSSI.....Hardware issue and Attenuation settings

[Yaaqob1982]

2 reasons for LOW RSSI.....Hardware issue and Attenuation settings
what's the meaning of RSSI

[Stantheman]

Received Signal Strength Indicator, usually a calibrated analogue voltage or digital output that is relative to input signal into the receiver, usually in dBm. The RSSI value to input signal level is usually reasonably linear except at the lower sensitivity levels of the receiver (geting down into the noise) and up at the point where the receiver line up prior to the RSSI detection point is starting to go into saturation. The RSSI curve can change slightly with operating temperature.

[jamal]

Hi Mate,

May be you can xcheck on UL interference level.

Hope help.

[MAZ29]

if you are sure of VSWR is ok for Cables , then do ( Hard Reset ) ==> turn off the power and wait for about 2 minutes then turn it On again , i had the smae problem and this was the solution ............