thewatcher
2012-04-26, 08:49 PM
Dear Expert,
We have a cabinets that are used once in a while, all are E******* RBS2106.
To save on their energy consumption I tried halting the RBS with the
RLSTC:CELL=XXX,state=halted;
command to all 3 cells in the RBS.
The Power consumption reduction was small so I tired blocking the TG with the following command,
RXBLI:MO=rxotg-XX,SUBORD;
The power consumption reduction was about the same.
These commands reduce around 1/3 of the RBS energy consumption.
I was told that it is possible to reach 60-70 % power consumption reduction just by halting/blocking all the cells in the RBS.
What am I doing wrong?
Is there some power management configuration in the RBS that prevents the power reduction?
Any advice would be appricated
Thanks!
We have a cabinets that are used once in a while, all are E******* RBS2106.
To save on their energy consumption I tried halting the RBS with the
RLSTC:CELL=XXX,state=halted;
command to all 3 cells in the RBS.
The Power consumption reduction was small so I tired blocking the TG with the following command,
RXBLI:MO=rxotg-XX,SUBORD;
The power consumption reduction was about the same.
These commands reduce around 1/3 of the RBS energy consumption.
I was told that it is possible to reach 60-70 % power consumption reduction just by halting/blocking all the cells in the RBS.
What am I doing wrong?
Is there some power management configuration in the RBS that prevents the power reduction?
Any advice would be appricated
Thanks!