High CONERRCNT only on SDCCH Time slots

[ejamhas]

Hi E/// Experts,

What could be the reason of high CONERRCNT only on the SDCCH TS where as on the same TRX TCH TS have very low CONERRCNT. The cell have high SD Drops due to other reasons.

Please help me identify the cause and propose some solution.

Many thanks in advance :)

Regards

[DizX]

Try to Change SD Time Slot and see if errors still persist on Signalling Channel or not.

If Errors Vanish: Change dtru

Else

Check lapd congestion from LAPD Sts Object, LU Load at LAC Border
Optimize LAPD Concentration Factor in case of high LAPD Congestion and necessary steps for LA Optimization in case of LU load is high

Further run LAPD report to check transmission status on signalling channel

hope it will help

[ejamhas]

Hi DizX,

Many thanks for the help. Well CONERRCNT is high only for the SD TS and TCH TS on the same TRX have no issue. I have also checked the LAPD and DIP status. All is well as per those reports.

I am going to change the TN for SD TS and will share the results.

Thanks again for helping me out :)


Try to Change SD Time Slot and see if errors still persist on Signalling Channel or not.

If Errors Vanish: Change dtru

Else

Check lapd congestion from LAPD Sts Object, LU Load at LAC Border
Optimize LAPD Concentration Factor in case of high LAPD Congestion and necessary steps for LA Optimization in case of LU load is high

Further run LAPD report to check transmission status on signalling channel

hope it will help