koepret
2011-06-11, 02:29 AM
This document describes how to perform DTs and CQTs. The involved test items include the Ping test,
FTP test, and HTTP test. The involved scenarios are as follows:
Single BS verification test
RF optimization test
Service optimization test
Acceptance test
Benchmark test.
Chapter 1 describes the document structure.
Chapter 2 describes test items of WiMAX DTs and CQTs that are performed with the GENEX Probe. The following information is described:
Preparations, procedures, and scenarios for each test item
Preparations for each service test
Standardized test operations
Chapter 3 describes the following DT and CQT test scenarios:
Single BS verification test
RF optimization test
Service optimization test
Acceptance test
Benchmark test
Test requirements vary with scenarios.
Chapter 3 also describes all baseline key performance indexes (KPIs) in DTs and CQTs for service optimization, including the following information:
Formulas and definitions
Signaling measurement points
Test conditions
Test and measurement methods
Chapter 4 summarizes the whole document.
Chapter 5 lists all templates and appendixes used in this document.
Chapter 6 lists appendixes and describes related signaling flows and evaluation methods.
this e-book is guide , how to DT &CQT for WIMAX Nework
is good ebook from my part :)
enjoy it
Koepret
===================
Please kindly add thanks and my reputation :)
FTP test, and HTTP test. The involved scenarios are as follows:
Single BS verification test
RF optimization test
Service optimization test
Acceptance test
Benchmark test.
Chapter 1 describes the document structure.
Chapter 2 describes test items of WiMAX DTs and CQTs that are performed with the GENEX Probe. The following information is described:
Preparations, procedures, and scenarios for each test item
Preparations for each service test
Standardized test operations
Chapter 3 describes the following DT and CQT test scenarios:
Single BS verification test
RF optimization test
Service optimization test
Acceptance test
Benchmark test
Test requirements vary with scenarios.
Chapter 3 also describes all baseline key performance indexes (KPIs) in DTs and CQTs for service optimization, including the following information:
Formulas and definitions
Signaling measurement points
Test conditions
Test and measurement methods
Chapter 4 summarizes the whole document.
Chapter 5 lists all templates and appendixes used in this document.
Chapter 6 lists appendixes and describes related signaling flows and evaluation methods.
this e-book is guide , how to DT &CQT for WIMAX Nework
is good ebook from my part :)
enjoy it
Koepret
===================
Please kindly add thanks and my reputation :)