I have the USB serial data cable and my MTH800 was corrupted too there is 3 months ago but with the LAB version i could write the entire codeplug and then it was OK
I have the USB serial data cable and my MTH800 was corrupted too there is 3 months ago but with the LAB version i could write the entire codeplug and then it was OK
Got Scout 8.10.29 run under Win8.1 x64! Any newer versions out there that still work with the emu?
Hi Nintrew,
I modify the pinout to radio and connected the pin13 to ground, ever with my USB cable but I do not have any COM port displayed.
When I connect/disconnect my cable, the radio now display me "RS232 cable Connected/Disconnected".
Then, Scout does not display the radio...
Thank you, but if it is possible to send me again the link for the RS232 cable low cost around $4.00, it could be kind.
Have a nice week end
Hello!
Could anybody please share Scout Version 10,11 or 12?
Thanks!
Best regards!
@tartare: you can't use the usb cable itself - you need a usb to rs232 cable and connect the rs232-end to the specified contacts on the radio connector.
or you just go for that: www.ebay.com/itm/160864226746
this cable is for ******** iDEN devices, but works well with tetra too
Hi!
I use the NKN6544B for my MTH800. It only works, when i connect the trvelcharger at the Datacable.
Best regards
that is strange - i have both, the cable and the same radio and i don't need the powercable
what's your firmware-version?
Last edited by nintrew; 2015-01-27 at 07:26 AM
Thanks Nintrew for info!
Last week, I ordered this one: http://www.gsm-support.net/en/data-c...-v70-v120-p234 , I am winting for to receive and I will leave a feedback when I'll use Scout.
I hope to receive it ASAP!!
Have a nice day
i guess, this will be fine too.
tell us, if it works, as soon as you have it
Bookmarks