How we can calibrate a propogation model in one live network
Dear Experts
How we can calibrate a propogation model in one live network (network already on air) knowing that the frequency planning is very bad due to insufficient number of frequencies of the operator.
I already started the measurement by locking the mobile on one BCCH but a drop call is experienced once I went a little far from the cell object of the study.
have you an experience in model tuning in a live network.
How we can calibrate a propogation model in one live network (network already on air) knowing that the frequency planning is very bad due to insufficient number of frequencies of the operator.
I already started the measurement by locking the mobile on one BCCH but a drop call is experienced once I went a little far from the cell object of the study.
have you an experience in model tuning in a live network.
Thanks for your support
my friend, for propagation model tunint, all your drive test should be in idle mode
Thanks for your answer
even if it will be in idle mode the model will make a re-selection to another cells using the same BCCH.
Find attached a picture describing the situation :
Re: How we can calibrate a propogation model in one live network
you can tune the Propagation model in Planning tool by using live network ideal mode DT data with some processing of DT data. Export the DT data in to .fmt format using the attached handset then filter each BCCH, BSIC combination Data one by one then use it in tool for tuning model.
Bookmarks