-
Junior Member
Reputation: 13
Direct audio from MTM5400
Hello everybody
I'm working on a tetra gateway with mtm5400, and while looking at the installation manual I see there's a tx_audio and rx_audio pins on the accessory connector...
I'm wondering can use them instead of speaker and microphone with audio transformers?
Thanks.
-
2024-02-13 02:30 AM
# ADS
Circuit advertisement
-
Member
Reputation: 208
1 out of 1 members found this post helpful.
Re: Direct audio from MTM5400
-
Post Thanks - 1 Thanks
-
Junior Member
Reputation: 13
Re: Direct audio from MTM5400
Originally Posted by
starter
Hello everybody
I'm working on a tetra gateway with mtm5400, and while looking at the installation manual I see there's a tx_audio and rx_audio pins on the accessory connector...
I'm wondering can use them instead of speaker and microphone with audio transformers?
Thanks.
If I can ask a question on what you working on, are you doing the DMO gateway? and, is it possible to use an MTM5XXX radio as a gap filler or to repeat a TMO signal?
-
Post Thanks - 1 Thanks
-
Member
Reputation: 15
Re: Direct audio from MTM5400
Originally Posted by
kideoIP
If I can ask a question on what you working on, are you doing the DMO gateway? and, is it possible to use an MTM5XXX radio as a gap filler or to repeat a TMO signal?
For that you can use Gateway mode.
-
Post Thanks - 1 Thanks
-
Junior Member
Reputation: 13
Re: Direct audio from MTM5400
Originally Posted by
580-Gabor
I'm starting experiments. Thanks
Originally Posted by
kideoIP
If I can ask a question on what you working on, are you doing the DMO gateway? and, is it possible to use an MTM5XXX radio as a gap filler or to repeat a TMO signal?
Yes, I'm working on DMO Gateway. I'm not very familiar with TMO, but as es4tix said, I think it's possible.
Bookmarks