Hi there,
you need this:
MR5.8 LAB CPS.ZIP:
https://mega.nz/file/RFsFBDiQ#Da_eGb...uSN8jwgC7tqN-g
You need Windows XP 32bit OS and USB-connector.
Setup the USB driver.
FOR USER LEVEL LAB:
User: Lab
Password: Lab or lab
Now you can run the Legacy CPS.
Plug in the USB programming cable (SKN6311B). Set the connection type to USB in the CPS (after successful previous USB driver setup).
Plug the programmer to the radio.
1+9+Power - now you are in programming mode.
Read device and save the orginal codeplug!
Upgrade therminal to the highest version! (6911, 6517 or 6511).
If done, read terminal, save codeplug.
You can try upgrade again, if you reached the highest version, there is no upgarde avaible.
Now done, you have migration version FW/SW on your radio!
You need the 6911, 6517 or 6511 .z19 firmware files (i don't have them for the MTP850 - do not ask for them from me).
Now its time run the CPS Plus Depot
Import the
MR5.9.1_NonE2E_Clear_FW6517_R01000001.rpk,
MR5.10_NonE2E_Clear_FW6911_R01000001.rpk,
MR5.14.9a_NonE2E_Clear_FW8465_R06023500.rpk
Now you can read your terminal with the CPS PLUS DEPOT.
Read your FW6XXX codeplug and save it.
Uprade your terminal – choose the 8495 version.
If done:
Read the device and save the codeplug – if you have trouble to do that, upgarde the USB driver (setup was for old FW, now you have new version).
Done.
Bookmarks