Thanks Thanks:  0
Showing results 1 to 3 of 3

Thread: Ue inactive timer(s)

  1. #1
    Member Reputation: 16
    Join Date
    2009-07-24
    Posts
    45


    Default Ue inactive timer(s)

    what is the impact of Ue inactive timer(s) on PRB utilization if it's reduced

  2. # ADS
    Circuit advertisement
    Join Date
    Always
    Posts
    Many
     

  3. #2
    Member Reputation: 108
    Join Date
    2015-01-07
    Posts
    136


    1 out of 1 members found this post helpful.

    Default Re: Ue inactive timer(s)

    Hi,

    I think the UE inactivity timer has no direct effect on the PRB utilization. However if you set the timer to too short, you will see an increase in the signalling load (paging, RRC setups etc.), and maybe some increase in the RRC connection setup failures (the more state transitions your enodeb has, the more likely you will see some increase in RRC setup failure rate).

    In live networks, the typical UE inactivity timer is set between 10-20 seconds (Huawei defaults to 20s). For WTTx you might want to increase that to 30-40 seconds. But you will need to experiment, and set the value based on the typical user behavior in your network.

  4. #3
    Member Reputation: 136
    Join Date
    2011-09-08
    Posts
    57


    1 out of 1 members found this post helpful.

    Default Re: Ue inactive timer(s)

    Normally the default value of the inactivity timer is 20 s and you can decrease it to 10s.
    the above activity wont have a noticeable impact on the PRB utilization but you will relief the network if you have RRC congestion and your are limited by the RRC license on the enodeb
    In addition you will notice improvement in the below:

    1- significant improvement in the E-RAB drop(since you are releasing the RRC, hence, you will have a lower probability of drop.
    2-RRC setup SR will increase
    3-E-RAB setup SR will increase
    4-S1 Signaling SR will increase
    5-ULIBLER will decrease
    6-Higher modulation schemes % will increase
    7-CPU load might increase
    8- you might face a degradation in the UL throughput which is only reflected KPIs wise and not on the user experience. It is related to the access procedure.
    L.Thrp.bits.UE.UL.LastTTI will increase.

Bookmarks

Bookmarks

Posting Rules

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •