Thanks Thanks:  0
Showing results 1 to 9 of 9

Thread: Nokia / EADS guru wanted

  1. #1
    Member Reputation: 35 AnRegs's Avatar
    Join Date
    2012-11-19
    Posts
    160


    Question Nokia / EADS guru wanted

    Hi all!

    I am looking for EADS TETRA guru. Are you here? A few questions to you:

    1. Is there an service commands / engineering menu please (FW version, active cell info, freqs, etc.)?
    2. Is there any SW/FW compatibility matrix? Because I noticed that some newer TPT can't read older radios.
    3. How about any RC-xx band designator? Because I stick with some strage situation when sticker on my radio doesn't match designator in Phone info.
    4. Some other things (come later).

  2. # ADS
    Circuit advertisement
    Join Date
    Always
    Posts
    Many
     

  3. #2
    Junior Member Reputation: 12
    Join Date
    2018-01-10
    Posts
    53


    Default Re: Nokia / EADS guru wanted

    Thr-4 THR880 380-400
    RC-2 THR880i 380-400
    RC-4 THR880i 410-430
    RC-6 THR880i 450-470
    RC-7 THR880i/lite 380-400
    RC-10 THR880i 380-430
    RC-27 THR9ex 445-470 or similar
    RC-31 THR9ex 380-430

    I hope this will get you started. I might have mixed up some of these (THR9ex for example)
    Last edited by Shuttleman; 2018-08-23 at 02:02 PM Reason: Corrections

  4. #3
    Member Reputation: 35 AnRegs's Avatar
    Join Date
    2012-11-19
    Posts
    160


    Default Re: Nokia / EADS guru wanted

    My THR880i RC-10 (accordingly to the silver sticker inside the radio), but box says TETRA 450 (and its actually 450-470 MHz). Box is genuine with TEI matches. I have a few of these radios all new in box and they are all the same.

  5. #4
    Member Reputation: 207
    Join Date
    2014-03-09
    Location
    Hungary
    Posts
    495


    Default Re: Nokia / EADS guru wanted


    RC-1: TMR-880 (TMO: Tx410 –420 MHz Rx 420 –430 MHz, DMO: 410-430MHz)

    RC-3: THH-880 800 MHz (TMO: Tx806 –825 MHz Rx 851 –870 MHz)
    RC-5: TMR-880 (TMO: Tx806 –825 MHz Rx 851 –870 MHz, DMO: 806-825MHz)

    RC-13: THR-880Ex 410 MHz -version

    RC-19: THR-9 350MHz version
    RC-20: THR-9 380 - 430 MHZ (Wideband)
    RC-36: TH-1n (Wideband EU Gov band)

  6. #5
    Member Reputation: 35 AnRegs's Avatar
    Join Date
    2012-11-19
    Posts
    160


    1 out of 1 members found this post helpful.

    Default Re: Nokia / EADS guru wanted

    A few more questions please.

    Any pros and cons of using FPS-8 or FPS-10? From what I see, FPS-10 model requires Smart Card to work. But FPS-8 requires only .ini file to activate. I think that both activations is linked to particular FPS device, and will work only with it.

    1. Which model is more ham-friendly, 8 or 10? And why?
    2. Is it possible to get/generate .ini file for FPS-8 by some unofficial method?
    3. Are there any chances to get service cable schematics (RJ-45 to THR880i)? It must include 2 wires with flashing voltage.

  7. #6
    Member Reputation: 35 AnRegs's Avatar
    Join Date
    2012-11-19
    Posts
    160


    Default Re: Nokia / EADS guru wanted

    Hi all!

    Again looking for EADS guru!

    Have THR880i with 5.24-1 software. Radio sees no DMO repeater when programmed appropriately (there is no repeater "in range" indication). When transmit from terminal, it shows [T] icon and transmits in Ms-Ms mode (radio-to-radio DMO, but radio to DMO-RPT):



    When terminal listens to the repeater, it receives voice well and shows [R] icon:



    Finally all looks like terminal can't initiate outgoing call to the repeater.

    More info:

    - MCC/MNC matches to the repeater (but there are no restrictions set at the repeater, so MNC/MNC can be any other)
    - "DM-REP supported" enabled in DMO Control of terminal
    - Before TX, terminal is allowed to receive repeater's beacon a few times (just to be sure)
    - AIE is set to Clear at terminal
    - Radio is 450-470MHz and working in its factory range (not out of band)
    - Programming has done by TPT 2010.08.64.2
    - Repeater vendor doesn't matter, terminal fails in all cases

    All air parameters of terminal looks fine in TETRA Demodulator (plugin for SDR#).

    Any ideas, guys?



    Last edited by AnRegs; 2019-01-28 at 04:41 AM

  8. #7
    Member Reputation: 207
    Join Date
    2014-03-09
    Location
    Hungary
    Posts
    495


    Default Re: Nokia / EADS guru wanted

    Dear AnRegs,

    i have the same issue, but only with ******** DMO-repeater.
    Cleartone, Sepura works fine.

    Another issue with my THR-880(i):
    won't receive anything from ******** terminals.

    I think it is frimware problem, becouse my THR-9 is ok (totally same programming).
    It is time upgrade the firmware (but how end where?)
    Teher is FW V7.93-1 for the THR880 series from 05.2018!

    (My programming software for the terminals: TPT 2009.20.53.7 and standalone version 2012.50.0000.49146, ITSI HL15.16-06)

    DMO control:
    DMO CONTROL.jpg
    DMO channels:
    DMO CHANNELS.jpg

    Firmware versions table:
    https://mega.nz/#!VY1jRKwR!pEn5mqfSw...t96Ki7Rck7pXZY
    Last edited by 580-Gabor; 2019-01-28 at 05:19 PM

  9. #8
    Member Reputation: 35 AnRegs's Avatar
    Join Date
    2012-11-19
    Posts
    160


    Default Re: Nokia / EADS guru wanted

    Hi Gabor!

    Okay, good to know.

    In my case, it doesn't work for SEPURA SRG repeater. Don't have any ******** repeater to try.

    Do you have access to any EADS firmware? I have almost all necessary hardware to perform upgrade and probably can do it.

  10. #9
    Junior Member Reputation: 9
    Join Date
    2019-06-22
    Location
    End of the World Brazil
    Posts
    2


    0 out of 1 members found this post helpful.

    Default Re: Nokia / EADS guru wanted

    Nokia EADS Nokia TMR880 DMO

    Good night I need help for the Nokia devices I need the Nokia Radio TMR880 Setup Software and the RIB programming cable,how to mount a cable . How to program the TMR880 to operate in Direct Mode,I can not program my two radios, someone know the code to access the extended level of programming?

    Diffulty setting the TMR880 radio to operate in Direct Mode (DMO) and password of acesso level EADS does not provide technical support,information and acessories.

    Can someone help me?

    Thanks good night best regards Bruno Schagas.

    https://www.youtube.com/watch?v=NEGwaSh18DY&t=10s



Bookmarks

Bookmarks

Posting Rules

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •