mapping LTE RS, PA and PB parameters in Atoll

[dannthemann]

Hi all,

I am trying to configure an LTE TDD scenario in Atoll for Huawei equipment.

As you know, there are some parameters regarding power allocation in LTE. Two of these parameters are:

PA
PB

Do you know which parameters in Atoll for LTE match with PA and PB?



Thanks!!

[DANORM]

not sure for TDD but i guess it will be same. Check below mentioned parameters

2018-01-25_9-55-41.jpg

[dannthemann]

OK, I guess that the -3 in your table is the PA value. Is correct?

Can't I configure the PB in Atoll? I have been looking for this parameter (PB or equivalent) in all the Atoll configuration templates, but I didn't succeed.

Thanks!

[DANORM]

not sure for pa but for pb that PDSCH offset should be. I guess one of that offset can control