-
Member
Reputation: 21
mapping LTE RS, PA and PB parameters in Atoll
Hi all,
I am trying to configure an LTE TDD scenario in Atoll for Huawei equipment.
As you know, there are some parameters regarding power allocation in LTE. Two of these parameters are:
PA
PB
Do you know which parameters in Atoll for LTE match with PA and PB?
Thanks!!
-
2018-01-24 10:57 PM
# ADS
Circuit advertisement
-
VIP Member
Reputation: 1716
Re: mapping LTE RS, PA and PB parameters in Atoll
not sure for TDD but i guess it will be same. Check below mentioned parameters
2018-01-25_9-55-41.jpg
-
Post Thanks - 1 Thanks
-
Member
Reputation: 21
Re: mapping LTE RS, PA and PB parameters in Atoll
OK, I guess that the -3 in your table is the PA value. Is correct?
Can't I configure the PB in Atoll? I have been looking for this parameter (PB or equivalent) in all the Atoll configuration templates, but I didn't succeed.
Thanks!
Last edited by dannthemann; 2018-01-25 at 06:06 PM
-
VIP Member
Reputation: 1716
Re: mapping LTE RS, PA and PB parameters in Atoll
not sure for pa but for pb that PDSCH offset should be. I guess one of that offset can control
Bookmarks