-
Member
Reputation: 264
Power Control Parameters Message in CDMA
Dear expert
The Power Control Parameters Message (PCNPM) parameters (received during drive test) are as :
pwr_rep_thresh = 0 (0x0)
pwr_rep_frames = 5 (0x5)
pwr_thresh_enable = 0 (0x0)
pwr_period_enable = 1 (0x1)
pwr_rep_delay = 0 (0x0)
but the parameters in the BAM of BSC6680 are
pwr_rep_thresh = 2 (0x2)
pwr_rep_frames = 9 (0x9)
does any one know where these values came from?
what the commands to change them?
I appreciate your help.
-
Post Thanks - 1 Thanks
-
2017-10-13 07:57 AM
# ADS
Circuit advertisement
-
Re: Power Control Parameters Message in CDMA
it is best to check the L3 signaling spec at http://3gpp2.org/Public_html/Specs/C.S0005-0_v1.0.pdf
"Upper Layer (Layer 3) Signaling Standard for cdma2000 Spread Spectrum Systems (3.2MB)"
-
Post Thanks - 2 Thanks
-
Member
Reputation: 264
Re: Power Control Parameters Message in CDMA
Originally Posted by
T_ADD
Thanks for your kind, I will check
-
Post Thanks - 1 Thanks
Bookmarks