AnRegs, FC3000 is programmed via serial interface, whilst VS4000 via Ethernet connection.
Therefore FC3000 is programmed with the same software, ad Puma T3/T3+ software. FPG3 (control panel) programming is included in the PRP software for Puma/FC3000 programming
Originally Posted by AnRegs
FC3000 software must be the same as for VS3000-3 and VS3000GTW terminals.
No mate.
Because VS4000 is programmed via Ethernet connection, but Puma and FC3000 via serial (PEI, RS232) interface, the Selex PRP software for VS4000 is different to that, used for Puma/FC3000.
This is a screenshot from User Manual for PRP software for Puma/FC3000 Selex PRP Puma.jpg
This is a screenshot from User Manual for PRP software for VS4000 Selex PRP VS4000.jpg
AnRegs,
I don't have experience with VS3000-3 or VS3000GTW. However, according to the User Manual (and screenshot in my other post), FC3000 and VS3000 are programmed with same PRP.
Originally Posted by AnRegs
FC3000 software must be the same as for VS3000-3 and VS3000GTW terminals.
AnRegs,
I don't have experience with VS3000-3 or VS3000GTW. However, according to the User Manual (and screenshot in my other post), FC3000 and VS3000 are programmed with same PRP.
does anyone have pinouts scheme to solder programming cable?
Bookmarks