someone here have try montecarlo simulation with 3.3.2.10366?
i try, but at statistic did not show any value like below 2017-02-03_23-20-30.jpg 2017-02-03_23-20-44.jpg
is there any suggestion?
thanks in advance
~do not wait to strike till the iron is hot; but make it hot by striking~
I've tried and its working. Check traffic maps and zones where you are making simulation. Check the demanded services and all parameters in Network settings
I've tried and its working. Check traffic maps and zones where you are making simulation. Check the demanded services and all parameters in Network settings
thanks bro...now its normal again...
~do not wait to strike till the iron is hot; but make it hot by striking~
Need Help
How to set cell parameter for layering priority for montecarlo simulation
i hace 2 layer, FDD Band 7 [2600] CHBW 20MHz and another is FDD Band 3 [1800] with 15 MHz ChBW, when simulation finish, user connected to L1800 is 3 times from user connected at L2600, i try to change Min RSRP, but still same.
BTW PMax setting is 30Watt for every 10 MHz ChBW.
maybe someone can suggest me how to setting up cell para at atoll to make layering priority
~do not wait to strike till the iron is hot; but make it hot by striking~
Which one is SCell and PCell? I guess if L18 is PCell users with low throughput demand should be connected more than CA users, also check the weights for user distributions in traffic map configurations.
Originally Posted by krobelux
Need Help
How to set cell parameter for layering priority for montecarlo simulation
i hace 2 layer, FDD Band 7 [2600] CHBW 20MHz and another is FDD Band 3 [1800] with 15 MHz ChBW, when simulation finish, user connected to L1800 is 3 times from user connected at L2600, i try to change Min RSRP, but still same.
BTW PMax setting is 30Watt for every 10 MHz ChBW.
maybe someone can suggest me how to setting up cell para at atoll to make layering priority
Bookmarks