How to use Actix to analyze indoor log?

[dsdd]

How can I open nemo indoor log (nmf and mrk) in Actix? Please help me show the result in Actix. Thank you so much.

[Rooster[BG]]

Dear dsdd,

First, both .nmf and .mrk files must be in the same directory.
The following description concerns measurements without GPS placed on layouts without real coordinates.
In Actix you should be careful about the used coordinate system.
1. By default "GPS Transformation" (from Actix settings) is set to "Default (meters)". You should change this setting to "Non-Earth (Nemo Indoor) (degrees)" which is at the bottom of the list.
2. If location binning is used, you can choose "Default (meters)" and select appropriate bin size.
3. To be sure that MapInfo exports will be placed in the right place you should add the layout to the map and see if the KPI goes at the correct place.
4. Make the necessary exports, workbooks, etc.

Please note that layouts should use measurement unit "meters" (you may open the TAB file) to match the exports from Actix in MapInfo.

Regards,
Rooster[BG]