Thanks Thanks:  14
Page 1 of 3 123 LastLast
Showing results 1 to 10 of 21

Thread: Tems Investigatiion 16.3.3 released

  1. #1
    VIP Member Reputation: 1216 husseinmanaf's Avatar
    Join Date
    2010-07-10
    Location
    Tems World
    Posts
    659


    1 out of 1 members found this post helpful.

    Default Tems Investigatiion 16.3.3 released

    Hi Friends

    Tems Investigation 16.3.3 released and installer in attachments

    1.About This Release
    © Ascom 2015. All rights reserved.
    TEMS is a trademark of Ascom. All other trademarks are the property of their respective holders. Apple, the Apple logo and iPhone are trademarks of Apple Inc., registered in the U.S. and other countries.


    2.Important Information


    2.1.Disabling Wi-Fi for Mobile Network Testing


    Before using state-of-the-art devices such as Sony Xperia Z2 or Samsung S5 models for mobile network data service testing, be sure to turn off Wi-Fi on the device. If Wi-Fi is enabled, the device may run data transfers over Wi-Fi rather than over the mobile network it is camping on (even if a correct APN has been entered).
    2.2.Rohde & Schwarz TSMW Firmware Upgrade
    All customers using Rohde & Schwarz TSMW scanners must upgrade to firmware version 2.0.1 to be able to connect the scanners in TEMS Investigation 16.3 and later.
    Please refer to „ www.rohde-schwarz.com/en/firmware/tsmw for R&S firmware download and release notes describing how to upgrade the firmware.
    2.3.VoLTE vs. Data Service Testing with Qualcomm Based Samsung Devices
    Qualcomm chipset based Samsung devices with VoLTE capability need to be set up differently depending on what services are to be tested: VoLTE, data, or both. Here are some guidelines:
    •If you are going to test VoLTE only, the device should be either in USB mode DM+MODEM+ADB, or in USB mode MTP+ADB and tethered. Please remember to start the OnDevice IP Sniffing service from TEMS Investigation.
    •If you are going to test data services only, and you need to keep down the size of the logfiles, either disable the DPL log (0x11EB) or set USB mode to RNDIS+DM+MODEM. Be aware that in RNDIS+DM+MODEM mode it is not possible to apply certain control functions such as RAT and band lock. In TEMS Investigation 16.3.1 the DPL log is by default turned off in RNDIS+DM+MODEM mode.
    •If you want to test both VoLTE and data services concurrently, the device must be in USB mode MTP+ADB and tethered if the data testing is to be done over the Ethernet interface. DM+MODEM+ADB will only provide a Dial-Up connection (RAS).

    3.TEMS Investigation 16.3.3


    3.1.Enhancements
    •License Control Center update checker states explicitly if the latest version is already installed (instead of just staying silent).
    3.2.Corrected Bugs
    •Second carrier information in HSPA dual cell scenario sometimes not presented from Sony Xperia LT25i.
    •Logfile export failed in TEMS Investigation 16.3: export output files were corrupt.
    •GPX file caused RouteUtility to crash. – The reason was that the Split by Region function in RouteUtility did not support GPX files containing a track (as opposed to a route). This has been fixed.
    •If several cells in CDMA active set had both channel and PN identical, cell names were not presented for these cells.
    •LTE signal scan with PCTel scanner on TDD bands did not appear in presentation windows.
    •Second call not answered when executing voice call script on Sony Xperia Z3 phones. – Hardcoded 500 ms preguard added before answer call activity for Qualcomm chipset based devices.
    •Bahrain not covered by TEMS Investigation MEA Edition.
    •TEMS Investigation 16.3.2 crashed when loading TEMS Pocket logfile. – Bug fixed in handling of WCDMA CPICH scan data.
    •LTE PDCP UL/DL Throughput and RLC UL/DL Throughput information elements not selectable in Report Generator setup.
    •UARFCN lock function did not work on Samsung Galaxy S5 SM-G900I: the phone went into no service mode without rebooting.
    •Map plotting of route markers at an offset from the route did not work in TEMS Investigation 16.3.2.
    •ODM POLQA calls using Samsung Galaxy S5 phones timed out after 220 seconds.
    •LTE scanning with PCTel MX: Scanned Channel RSSI was not populated if no cells detected.
    •Events duplicated (or repeated even further) in MDM-format logfile export.
    Attached Files Attached Files
    Last edited by husseinmanaf; 2015-06-07 at 06:37 AM
    Thank You So Much For Click helpful or add reputation

  2. Thanks Roman99, kvf, slim09, supershuby thanked for this post
  3. # ADS
    Circuit advertisement
    Join Date
    Always
    Location
    Advertising world
    Posts
    Many
     

  4. #2
    VIP Member Reputation: 5092
    Join Date
    2009-10-01
    Posts
    2,418


    Default Re: Tems Investigation 16.3.3 released

    And the password is ...?

  5. #3
    VIP Member Reputation: 1216 husseinmanaf's Avatar
    Join Date
    2010-07-10
    Location
    Tems World
    Posts
    659


    1 out of 1 members found this post helpful.

    Default Re: Tems Investigation 16.3.3 released

    Hi friend

    Use this one direct download

    https://mega.co.nz/#!yNgWzJDb!QWOmiT...ljcDSTqvgcO_so

    Quote Originally Posted by Roman99 View Post
    And the password is ...?
    Thank You So Much For Click helpful or add reputation

  6. Thanks TIGRI007, Roman99, rkdrkd, fotondiamond, KidAngel, supershuby thanked for this post
  7. #4
    Member Reputation: 165
    Join Date
    2010-02-08
    Posts
    245


    Default Re: Tems Investigation 16.3.3 released

    Dear all, please help about a problem with this tems:

    When connecting samsung i9505 (not tems phone, normal qualcomm device) to Tems 16.3.3 and selecting "RMNET+DM+MODEM" option, the DL speed is very low ->till 4Mbps
    with tems 16.3.2 this problem was not present.

    Thank you in advance

  8. #5
    Member Reputation: 36
    Join Date
    2011-08-10
    Posts
    27


    Default Re: Tems Investigation 16.3.3 released

    Hi all,

    To connect i9505 is there any limitation with Android's version?
    Has anyone tried to connect S5?


    BR

  9. #6
    Member Reputation: 165
    Join Date
    2010-02-08
    Posts
    245


    Default Re: Tems Investigation 16.3.3 released

    Only limitation is the chipset which should be qualcomm.

  10. Thanks Roman99, supershuby thanked for this post
  11. #7
    Junior Member Reputation: 10
    Join Date
    2015-07-25
    Posts
    7


    Default Re: Tems Investigation 16.3.3 released

    we want direct download plz

  12. #8
    Senior Member Reputation: 496
    Join Date
    2009-12-07
    Posts
    244


    Default Re: Tems Investigation 16.3.3 released

    What about Med***?

  13. #9
    Junior Member Reputation: 12
    Join Date
    2014-12-02
    Posts
    10


    Default Re: Tems Investigation 16.3.3 released

    sir, can i get the installer + activation TEMs 16 ? thank

  14. #10
    Member Reputation: 453
    Join Date
    2009-12-31
    Posts
    251


    Default Re: Tems Investigation 16.3.3 released

    Does anyone have TEMS Inv 17?

Bookmarks

Bookmarks

Posting Rules

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •