-
Member
Reputation: 21
1 out of 1 members found this post helpful.
SDCCH Cong
Salam Team
Please your help for this case, i have some sites which they have a very high SDCONG (CNRELCONG), due to intermittence 3G sites(3G not stable),
I have added some SDCCH in CHGR1 but it causes some drops, so it affect the performances.
If there is some parametters to change, to avoid the drop caused by the modifications (SDCCH added in CHGR1)
Thank you for your help
-
Post Thanks - 1 Thanks
-
2015-03-31 06:07 PM
# ADS
Circuit advertisement
-
Member
Reputation: 61
Re: SDCCH Cong
Hi,
Please check your TCH or transcoder congestion.
CNRELCONG could be an indicator for both SDCCH congestion/SDDROP caused by TCH/transcoder congestion.
tnx,
-
Member
Reputation: 18
Re: SDCCH Cong
Dear check the cause for the service request, if it's due to location update it's means when the 3G sites fluctuate it cause high location update, you can change the parameter for 2G 3G cell reselection to push more traffic to 2g under the area where you are facing 3g sites fluctuatuion.
thx
-
Member
Reputation: 21
Re: SDCCH Cong
Hi Dear,
Ok, and thanks for your response, il already have this information, SDCCH cong and drops due to location update. you said that i can change the parameter for 2G 3G cell reselction to push more traffic on 2G, how it can be done given that i'm under E******* technology.
Thanks a lot
-
Member
Reputation: 18
Re: SDCCH Cong
Check the below parameters for e*******
QSearchI=7
FddQoffset= 0 You check and tune this parameter
FDDQmin= 3 (-8) or 5 (-10)
-
Post Thanks - 1 Thanks
tpkj thanked for this post
-
Member
Reputation: 21
Re: SDCCH Cong
Hi,
here what i get from printing on FDDQMIN:
<RLSUP:cell=XXXXXXA;
CELL SYSTEM INFORMATION UTRAN DATA
CELL
XXXXXXA
QSC QSCI QSI FDDMRR FDDQMIN FDDQOFF SPRIO FDDQMINOFF FDDRSCPMIN
15 0 7 0 6 0 YES
FDDREPTHR2
END
So here my question, if i change the FDDQMIN (and i will go to sever change) =1, is this will affect also the performances on the neighbors cell, or just the cell on question.
Thanks
-
Member
Reputation: 21
Re: SDCCH Cong
-
Member
Reputation: 18
1 out of 1 members found this post helpful.
Re: SDCCH Cong
Hi
Suggestion already provided.
QSearchI
FddQoffset
FDDQmin
-
Member
Reputation: 21
Re: SDCCH Cong
Hi oucht79
yes i check all those parameters, but my question it was about FDDQMIN: If i change it in one cell, the perfrormaces of the sites around the site that i have change the FDDQMIN will be affected or not ?
Thank you for your help
-
Member
Reputation: 18
Re: SDCCH Cong
Hi,
You have to change it in all neighbors cells of the 3G unstable site
BR
Bookmarks