-
Member
Reputation: 45
Sync Reference PDV Problem
Hi Experts
How to solve Sync Reference PDV Problem alarm in NodeB
Thanks
-
2015-02-17 08:03 AM
# ADS
Circuit advertisement
-
Member
Reputation: 22
Re: Sync Reference PDV Problem
First , I will assume that the site transmission is IP-RAN ,, ie that you using TCU or SIU at site ,, then the cause of this problem can be one of two things :
1- the circuit creation in the backhaul is different than the circuit configuration made at TCU ( check that the same scheme is used at both site and backhaul).
2- LOW MW Link Ethernet Capacity at site or in another site along the route (Use [ping xxx.xxx.xxx.xxx -c 100] command) where xxx.xxx.xxx.xxx is the PGW IP address for the 2G or RNC IUB IP Address , if there is packet loss , then check Ethernet capacity in site or along the route .....
Br//
-
Post Thanks - 1 Thanks
-
Member
Reputation: 83
Re: Sync Reference PDV Problem
Originally Posted by
freedman71
Hi Experts
How to solve Sync Reference PDV Problem alarm in NodeB
Thanks
Could you give more details?
Does your NodeB uses 1588v2 in order to obtain frequency and phase?
What type of backhaul you use?
-
Junior Member
Reputation: 12
Re: Sync Reference PDV Problem
How is the synchronisation of the RBS 3206?
-
Re: Sync Reference PDV Problem
Now is re-open.
regards
zeuscane
"Educate yourselves because we'll need all your intelligence.
Stir yourselves because we'll need all your enthusiasm.
Organize yourselves because we'll need all your strength."
-
Member
Reputation: 69
Re: Sync Reference PDV Problem
Anyone able to resolve this problem of PDV....
-
Member
Reputation: 83
Re: Sync Reference PDV Problem
Originally Posted by
bioda
Anyone able to resolve this problem of PDV....
Without information about the problem it seems difficult ...
-
Member
Reputation: 69
Re: Sync Reference PDV Problem
Hi,
Below is the extract from the NodeB guy,
How do we resolve.
ThanksCapture.jpg
-
Member
Reputation: 83
Re: Sync Reference PDV Problem
Originally Posted by
bioda
Hi,
Below is the extract from the NodeB guy,
How do we resolve.
Thanks
Capture.jpg
Based on the discussion so far and the image you post I suppose that NodeB has an
internal 1588 OC (slave) that cannot recover Frequency due to excessive PDV of PTP messages (SYNC message).
Does your NodeB recover Frequency only or both Frequency and Phase using IEEE 1588?
If so the cause for your problem is your transport network (the network between IEEE 1588 GrandMaster and NodeB). Could you give details of it?
-
Post Thanks - 1 Thanks
bioda thanked for this post
-
Re: Sync Reference PDV Problem
Hi I had this kind of problem many times.
Usually problem is because of bottleneck in the transport network causing high latency.
You can try to ping the Ipsync then see if there's high latency.
Bookmarks