-
Junior Member
Reputation: 10
MTH800: Erased flash
Hello,
I was performing several tests on my MTH800 Terminal yesterday, however in that process I have accidentally erased the complete flash, now my terminal is unable to start in flash mode anymore and now comes up as an unrecognized device in windows
is there a way to restore the software on it
-
2015-01-02 05:26 AM
# ADS
Circuit advertisement
-
Member
Reputation: 62
Re: MTH800: Erased flash
Yes, it is. You must connect terminal to CPS via RS232 cable.
-
Member
Reputation: 47
1 out of 1 members found this post helpful.
Re: MTH800: Erased flash
you don't need to spend money on the expensive tetra rs232 cable.
you can also use this ******** iDEN rs232 cable: NKN6544B
you will find them on ebay for ~5$
-
Post Thanks - 1 Thanks
-
Junior Member
Reputation: 10
Re: MTH800: Erased flash
Kdeam, it works this solution?
Do you solved the problem?
I have the same problem at my MTP850S radio...
-
Member
Reputation: 47
Re: MTH800: Erased flash
periquito, yes it works! i flashed my mth800 already twice back to life
-
Post Thanks - 2 Thanks
-
Member
Reputation: 77
Re: MTH800: Erased flash
I also confirm that it works.
-
Post Thanks - 1 Thanks
-
Junior Member
Reputation: 10
Re: MTH800: Erased flash
Thanks all
I'll buy the cable and will report my experience
-
Junior Member
Reputation: 10
Re: MTH800: Erased flash
Hi, I received the cable, but with no success.
I use CPS+ depot 6.0.2 and clicking on "detec radio on RS232 port" don't detects any radio. I tried the same with another correct operating radio and don't detects it too.
The cable and the computer works ok, and I tried the procedure with another PC.
May be I must use another old CPS version?
I have the original codeplug of the erased radio, and all release packs that I can need.
Somebody can help me?
I don't know if I need same flashtool aplication....
Thank you all for your time
-
Member
Reputation: 62
Re: MTH800: Erased flash
-
Junior Member
Reputation: 10
Re: MTH800: Erased flash
Bookmarks