-
Member
Reputation: 77
MOTOTRBO codeplug password recovery
I have this information and i would like to share it with you.
MOTOTRBO codeplug password recovery :
- Use wireshark.
- Start the cps, and start wireshark.
- Select the port the radio is connected to, and start wireshark recording / sniffing
- Read the radio, until it gets to the password input box.
- Go to wireshark and stop the recording
- Sift through the large data packet. It should be one of the last few sniffed if you stopped wireshark shortly after the password box came up
- You are looking for a word or numbers with full stops in between - so a password of 'password' would be displayed in wireshark as p.a.s.s.w.o.r.d
- It's usually just before the radio name, so if you are reading a display radio, then its very easy, just look at the display when you turn it on, and look for that in the wireshark dump.
I hope this tip may save you some time by avoiding complete reprogramming, enjoy ...
Last edited by kondoros; 2014-09-08 at 12:38 AM
-
Post Thanks - 1 Thanks
vr10 thanked for this post
-
2014-09-07 11:49 PM
# ADS
Circuit advertisement
-
Member
Reputation: 130
Re: MOTOTRBO codeplug password recovery
Hi,
Yep, this method works with previous firmware releases, but unfortunatly, it doesn't work anymore with latest firmware version...
-
Member
Reputation: 77
Re: MOTOTRBO codeplug password recovery
Which firmware version do you have ?
-
Member
Reputation: 77
Re: MOTOTRBO codeplug password recovery
For your information, ******** stated that starting from release 10.5 Build 551 EMEA the password will be encrypted during the transfer from radio to the PC.
That means that after this release only = no more interception with Wireshark.
-
Post Thanks - 1 Thanks
vr10 thanked for this post
Bookmarks