Magic Solution for improving TBF success rate

[gogotchiya83]

Hello,
In our Network we suffer from a bad TBF success rate ("Ms no response"), after a deep investigation Huawei recomand us to deactivate the "Flex HSN", and fortunately we had a very good result after this actions (we did it in many BSC with an improvement of the TBF success rate).
But we have some question, What can be the impact of that change in our network? what we have to verify in order to say that this feature doesn't serve to any things?
...

[ashraferto]

i will try it on one of our BSCs to see the result .. thanks

[bdplanner]

we also have good improvement after disabling "PS_DTX" parameter.

[gogotchiya83]

Dear Expert, How do you find the value of SD Drop lower than 0,01% for the whole network?
What is the logical value? i was with other operator and we have 0,5%,...

[bdplanner]

untitled.jpg


As u can see Failed TBF establishment due to MS no response has highly increased after enabling PS_DTX feature on 1st october and after disabling it is decreasing from 18th october

[kevin_h811]

@Amit,

What type of BSC are you referring to?BSC32,6000,6900,etc?

regards//

[bdplanner]

@Amit,

What type of BSC are you referring to?BSC32,6000,6900,etc?

regards//

6900; i think this is a new feature only with 6900

[dacoder]

6900; i think this is a new feature only with 6900

what is the parameter name for it in BSC6900? i didnt find "PS_DTX"

thanks

[bdplanner]

what is the parameter name for it in BSC6900? i didnt find "PS_DTX"

thanks

MO	Parameter ID	Parameter Name	NE
GCELLPRIVATEOPTPARA	PSDTX	PS DTX	BSC6900

[dacoder]

MO	Parameter ID	Parameter Name	NE
GCELLPRIVATEOPTPARA	PSDTX	PS DTX	BSC6900

i found that its only available in V900R013 onwards... any idea of similar parameter for V900R011. We are facing low TBF success rate in our network.

thanks