-
Member
Reputation: 18
Problem with SAE increase
Hi,
I want to increase SAE 17 but getting following error in core switch.
SIZE ALTERATION OF DATA FILES RESULT
SAE BLOCK NI NIE NIR
17
FAULT CODE 21
SAE MEMBER BUSY AT SIZE INCREASE
INF1 A
END
Does anyone know any solution of it.
Thnaks,
Am
-
2012-03-10 08:50 PM
# ADS
Circuit advertisement
-
Junior Member
Reputation: 5
Re: Problem with SAE increase
Wait and try again, and you see output local or global by command : DBTSP:TAB=SAACTIONS; ?
Last edited by quachthanhhung; 2012-03-11 at 01:00 AM
-
Member
Reputation: 146
Re: Problem with SAE increase
hI...Wish command did you use for increase the SAE?
SAAII or SAALI??
Probably first you must use other SAE in the same block (BLOCK=DA)....for example SAE=16 or SAE=109...etc.
All of this is for MSC Server.
-
Member
Reputation: 39
Re: Problem with SAE increase
Hello Mate,
Your problem is because you want to increase the individuals to be added to the A or B number analysis table. That result comes out when you try to alter the size of block DA while the non operating area of either tables contain data. Zero out first the the A or B number non-operating area by command ANAZI; or ANBZI; then try running the command. After you had successfully increased SAE 17, dont forget to copy the operating to the non-operating by command ANACI; or ANBCI; then run ANASP:A=ALL,COMP; or ANBSP:B=ALL,COMP;
Bookmarks