-
Junior Member
Reputation: 10
EDGE Traffic Optimization
How can I improve EDLIPTHRPUT of EDGE traffic on E******* node.
-
2012-03-06 08:47 PM
# ADS
Circuit advertisement
-
Re: EDGE Traffic Optimization
Please check following
1. CS traffic load, Site coverage Rf conditions to know exact issues. Following some parameters can also help in increasing thruput
PDCHPREEMPT, NUMREQEGPRSBPC
FPDCH |
Abis Resouces
-
Junior Member
Reputation: 10
Re: EDGE Traffic Optimization
Thanks for the quick response, The FPDCH is on 4, the efactor has been increased to 2, and the NUMREQEGPRSBPC is 4, what value can i increase PDCHPREEMPT to?
-
Re: EDGE Traffic Optimization
PDCHPREEMPT=8 which wll not allow voice to prempt data call... what are rf conditions normally of this cell....plus what is pdch sharing..
-
Senior Member
Reputation: 331
Re: EDGE Traffic Optimization
You can try changing the default coding scheme to higher ones. But it depends on radio interface though.
-
Junior Member
Reputation: 10
Re: EDGE Traffic Optimization
GPRSSUP BVCI FPDCH GAMMA PSKONBCCH LA CHCSDL
YES 4 0 ENABLED OFF NA
SCALLOC PDCHPREEMPT MPDCH PRIMPLIM SPDCH FLEXHIGHGPRS EFACTOR
UL NO 8 0 2
RTTI
-
Member
Reputation: 42
Re: EDGE Traffic Optimization
Originally Posted by
saeedulhaque
PDCHPREEMPT=8 which wll not allow voice to prempt data call... what are rf conditions normally of this cell....plus what is pdch sharing..
in the case of the parameter PDCHPREEMPT=8, it can happen to a congestion of voice? how will this affect CS services?
-
Member
Reputation: 44
Re: EDGE Traffic Optimization
huge PS traffic will impact to low throughput, try to check time slot utilization.
To improve throughput, try to allocate Edge TS (NUMREQEGPRSBPC) on CHGR 0.
PSKONBCCH must enabled
Try to PS balancing to surrounding cells, use idle parameters.
-
Member
Reputation: 44
1 out of 1 members found this post helpful.
Re: EDGE Traffic Optimization
Originally Posted by
GrayDog
in the case of the parameter PDCHPREEMPT=8, it can happen to a congestion of voice? how will this affect CS services?
PDCHPREEMPT
Type:
Numeral
Range:
0 to 8
Unit:
-
Default:
0
Command:
RLGSC, RLGSP.
O&M:
-
Comments:
Defines what kind of on-demand PDCHs are possible to preempt for the CS traffic:
0
No PDCHs protected
1
PDCHs used for DTM protected
2
PDCHS used for Streaming protected
3
PDCHs used for DTM and PDCHs used for Streaming protected
4
Essential PDCHs protected
5
Essential PDCHs and PDCHs used for DTM protected
6
Essential PDCHs and PDCHs used for Streaming protected
7
Essential PDCHs and PDCHs used for DTM and PDCHs used for Streaming protected
8
Busy PDCHs protected
Yap it will lead to TCH congestion, if you set PDCHPREEMPT = 8 or 4.
Try to reduce ODPDCHLIMIT from 100 to 80 to limit PS time slot. And adjust HR setting to 100 to get more voice time slot.
Bookmarks