Thanks Thanks:  1
Showing results 1 to 9 of 9

Thread: ALU 2G BTS dropping

  1. #1
    Junior Member Reputation: 9
    Join Date
    2010-11-25
    Posts
    44


    Cool ALU 2G BTS dropping

    Dear Experts
    Hi,
    I'm facing ALU BTS 1800 going down and sometimes up by it self
    Please note there is no Power or Transmission problem,
    Abis,OML and O&M remain up at the Suma board, Please assist to
    locate the root cause and explain more about DSP alarm sent from TREs.

    Regards

  2. # ADS
    Circuit advertisement
    Join Date
    Always
    Posts
    Many
     

  3. #2
    Member Reputation: 201
    Join Date
    2010-02-16
    Posts
    306


    Default Re: ALU 2G BTS dropping

    Interesting abnormal behavior of Alcatel GSM base station was observed. Sometimes, voluntary, without any reason or after BTS reset, some TRXs start malfunctioning in other words - generates excessive bad DL RxQuality (between rxqual 5-7 more than 60%).
    The Alcatel network runs under B10 release.
    Massive replacement of TRXs (~150) can not solve all issues. Observed excessive DL bad RxQuality may voluntary appear and voluntary disappear. Again it is DOWNLINK!!!!! No external interference in the network recognized. No frequency reuse issues - since no frequency plan changes.
    Simple BTS reset not solving a problem, TRX replacement solving problem only in 50-60% of cases.

    Does anyone experience similar problem? and what solution? Alcatel support still did not provide any answer for already 3 months.
    The network performance affected significantly, Drops, Bad voice quality

  4. Thanks evagtf@yahoo.fr thanked for this post
  5. #3
    Junior Member Reputation: 9
    Join Date
    2010-11-25
    Posts
    44


    Default Re: ALU 2G BTS dropping

    Hi,
    Have you tried to replace Internal/External Bus cable(remote inventory cable), and or OUTC board?.

    Regards

  6. #4
    Junior Member Reputation: 9
    Join Date
    2010-11-25
    Posts
    44


    Default Re: ALU 2G BTS dropping

    Hi Danikd
    I solved my indoor Alu Indoor BTS dropping issue after one TRX(that reported DSP alarm) shutdwn, since no dropping more than a week ago.
    now I keep focus on it, and then i'll swap the affected TRX.

    Regards.


    Quote Originally Posted by danikd View Post
    Interesting abnormal behavior of Alcatel GSM base station was observed. Sometimes, voluntary, without any reason or after BTS reset, some TRXs start malfunctioning in other words - generates excessive bad DL RxQuality (between rxqual 5-7 more than 60%).
    The Alcatel network runs under B10 release.
    Massive replacement of TRXs (~150) can not solve all issues. Observed excessive DL bad RxQuality may voluntary appear and voluntary disappear. Again it is DOWNLINK!!!!! No external interference in the network recognized. No frequency reuse issues - since no frequency plan changes.
    Simple BTS reset not solving a problem, TRX replacement solving problem only in 50-60% of cases.

    Does anyone experience similar problem? and what solution? Alcatel support still did not provide any answer for already 3 months.
    The network performance affected significantly, Drops, Bad voice quality

  7. #5
    Member Reputation: 304
    Join Date
    2009-02-12
    Posts
    449


    Default Re: ALU 2G BTS dropping

    ALU Guys,

    What would be the effect of the following components on KPIs;

    1) Faulty SUMA
    2) Faulty Combiner
    3) Faulty TCUC
    4) Faulty CPRC

    Kindly include other components on the BTS or BSC that may affect KPIs

  8. #6
    Member Reputation: 31
    Join Date
    2010-09-01
    Location
    Africa
    Posts
    60


    Default Re: ALU 2G BTS dropping

    Quote Originally Posted by Processor View Post
    ALU Guys,

    What would be the effect of the following components on KPIs;

    1) Faulty SUMA
    2) Faulty Combiner
    3) Faulty TCUC
    4) Faulty CPRC

    Kindly include other components on the BTS or BSC that may affect KPIs
    1) Faulty SUMA:

    Drastically degrade the handover efficiency for the whole site (site's three cells are affected).

    2) Faulty Combiner:

    The TRXs efficiency goes down affecting the most of major KPIs CDR, HO efficiency rate, SDCCH Drop, etc..

  9. #7
    Junior Member Reputation: 9
    Join Date
    2010-11-25
    Posts
    44


    Default Re: ALU 2G BTS dropping

    Hi ALU Guys
    Faulty TCUC :The OML is affected and the BTS loses communication with the BSC
    Faulty CPRC: You need to specify wich kind of CPRC(OSI or System)
    Faulty CPRC OSI: There is X25 link lost from OMC/NMC and some times N7 signalling link affected
    Faulty CPRC System: BSC software affected, BSC is down and all the sites controlled by the BSC.


    Regards

    Kindly include other components on the BTS or BSC that may affect KPIs[/QUOTE]

  10. #8
    Member Reputation: 304
    Join Date
    2009-02-12
    Posts
    449


    Default Re: ALU 2G BTS dropping

    what components impact on Preparation failures on BSS?

  11. #9
    Member Reputation: 314
    Join Date
    2007-09-03
    Posts
    213


    Default Re: ALU 2G BTS dropping

    Dear, please try to define if faulty TRXes have something common?
    1) common area/cluster
    2) common day of TRX production, cargo batch.
    3) common BSC/CPU/board/port
    4) common antenna type?
    5) common transmission type.
    6) common transmission node.
    7) common BTS software version?
    8) common time of faulty.
    9) common cklock sourse.

    After you find something common/ you can do drill insinde corrupted object.

Bookmarks

Bookmarks

Posting Rules

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •