E******* Mini Link Craft 1.1

[ofca]

@byja: Number of Traffic Class Queues - 8, it's in configuration of ethernet switch, and there are terms such as "Queues - Configure Packet Aging". Is this what you want?

[prle]

Speaking of ethernet transmission over mw radio, does anyone know how many traffic queues does TN have for QoS?
Most of the vendors have four traffic queues for 8 classes of service with fair or strict queueing, but I recently saw a request for eight. And I haven't seen any radio that supports it.

@byja

this is quotation from latest product description:

"All site LAN/WAN Ethernet ports can be configured with 1-8 traffic classes,
where 8 traffic classes are default.
The CoS priority information is used to map the Ethernet frames into the
1-8 traffic classes (TCs). The mapping can be done according to either
IEEE802.1D-2004, IEEE802.1Q-2005 or custom. Frames with no CoS
information is mapped to the default traffic class (TC0).
There are individual queues for each CoS. The Ethernet frames in the egress
queues are either scheduled according to a strict priority scheme or according to Weighted Fair Queuing (WFQ).
See Section 3.7.5.7 on page 47 for more information on strict priority, and Section 3.7.5.8 on page 47 for information on WFQ."

[Cost_Reducer]

Do you have R4.3.1 release notes yet?

here you must look and download

[itsartur]

...hi everybody

can someone tell me if the version 2.5 of minilink is already available.

thanks.

[Cost_Reducer]

...hi everybody

can someone tell me if the version 2.5 of minilink is already available.

thanks.

yes take a look into this forum and you can download it but please note that 2.5 is old, 2.7 is up to date

[itsartur]

hi Cost,

i look up the forum and didn't find nothing about minilink TN 2.7

[Cost_Reducer]

hi Cost,

i look up the forum and didn't find nothing about minilink TN 2.7

you can`t find the 2.7 here but you can find the Craft terminal 2.5 here...posted by me

[bassem_16]

Has anyone faced any strange behaviour in software release 4.3.1 ?
Any problems that did occur, I know for instance that ML CT 2.5 is a bit slow when dealing with it so 2.7 is much more faster.

But I'm talking about any serious problems or unexplained behaviours
Thank you

[Cost_Reducer]

Has anyone faced any strange behaviour in software release 4.3.1 ?
Any problems that did occur, I know for instance that ML CT is a bit slow when dealing with it so 2.7 is much more faster.

But I'm talking about any serious problems or unexplained behaviours
Thank you

Sir,

i can say for me that i haven`t any behaviours at the moment with this software package because i didn`t test it very deep. This SW baseline was written to fix a bug with the power supply into AMM6.

And yes, you are right, ML Craft 2.5 is not the fastest LCT

[bassem_16]

Thanks cost reducer

I was thinking more about BER, or Tx off from links , unusual behaviour
I've seen it and was thinking its related to this SW but maybe not after all