TEMS ACTIVATION K790i GDFS

[vibs75]

many thanks brother

[xiaoduirensheng]

good think
thangk you

[shahram]

I have tested and it works fine,

[Lesmana]

I have tested and it works fine,

To Shahram......

What about the calibration data? have u checked or compare the Rx_Levels by your TEMS activated K790i ?

[shahram]

the only way I could test it was to put it in similar situation with an original TEMS handset,and compare the result in TEMS Inv.
Almost the same result! (RxLev)
but there is no way to be sure about it theoretically,because falshing might cause to 2~3 dB offset in measurement which can't be so obvious during above test method.

[siborjong]

@shahram

bro, do you have software to flashing t610, i have tried for looking div lpt dongle but not get it

[Lesmana]

the only way I could test it was to put it in similar situation with an original TEMS handset,and compare the result in TEMS Inv.
Almost the same result! (RxLev)
but there is no way to be sure about it theoretically,because falshing might cause to 2~3 dB offset in measurement which can't be so obvious during above test method.

For K790i, Do i need any special data cable or the cable provided with the retail phone is enough for data collection.

[yy19820503]

Appreciation too, I just need to

[simri2god]

For K790i, Do i need any special data cable or the cable provided with the retail phone is enough for data collection.

Use cable provided with the phone (DCU-60)

[shahram]

yes,the retail cable is enough.
I was looking for DIV terminator too,since it is an old software it is hard to find,I had no chance,

good luck