-
Junior Member
Reputation: 11
Huawei HO Parameter
Could anyone tell me wich parameters must I change in Huawei HO to transfer the traffic between two sites? One of them is congested and I want to force some of the traffic of this site to uncongested ones.
Many thanks in advance!
Regards,
RB
-
2011-06-01 02:25 AM
# ADS
Circuit advertisement
-
Member
Reputation: 38
Re: Huawei HO Parameter
Hi
These sites are rural or Urban Ones?.
Rgds
lgy
-
Junior Member
Reputation: 11
Re: Huawei HO Parameter
In this case, they are urban sites.
Rgds,
RB
-
Re: Huawei HO Parameter
if your HO is ok, don't suggest to change any HO parameters. as this could possibly result in call drops.
instead suggest to start with the following:
1. check coverage of both sites. see amount of overlap etc.
2. optimise antenna downtilt, azimuth etc
3. reduce coverage if necessary
4. check congested site coverage and and neighbor sites. if traffic in congested site is more near to the site and has difficulty distributed to neighbor sites than yo u might have to consider channel and/or carrier expansion (if cdma), trx expansion (i think) (if gsm). you didn't mention what technology you using.
after these basic checks then only move to parameter modification. by the time you finish with the above, it might have solved your problem.
Last edited by T_ADD; 2011-06-01 at 06:27 AM
-
Member
Reputation: 18
Re: Huawei HO Parameter
please anyone tell us, how can we adjust congestion relief margins handover in huawei systems like ******** systems. There are so many load sharing parameters, but i couldn't find exact "congestion relief" parameter which i can adjust with dBm margins for handover.
-
Re: Huawei HO Parameter
Try to enable Load handover, and adjust the parameters related to the load to avoid call drops.
If the load HO is not successful to decrease the congestion, give the cell a lower priority temporary until you can solve your problem by a mechanical action, or capacity adding.
-
Member
Reputation: 18
Re: Huawei HO Parameter
Its not answer of my question;
for example i have one congested cell (X) and two neighbor cells (neighbor A & B).
when X congested i want to share load only to neighbor A,
i don't want to share load with neighbor B.
how can i adjust this with huawei handover parameters?
thanks
-
Member
Reputation: 26
Re: Huawei HO Parameter
why don't you try to modify the CRO?
-
Member
Reputation: 18
Re: Huawei HO Parameter
sorry but CRO is an idle mode parameter,
i need dedicated mode parameter for seperating target cells of a congested cell.....
thx
-
Junior Member
Reputation: 11
Re: Huawei HO Parameter
I already did all the physical optimization and now I want to try some parameters changes to balance the load between the sites but I don't know how Huawei parameters could manage and balance the traffic.
I already used Load HO but the impact on the traffic balance was very discrete. About 10% or less.
Have anyone some documentation about traffic management using Huawei HO paramenters?
Many thanks!
Bookmarks