Poor MPD in Huawei BSC 6900

[akmamit]

Hi,

There was poor MPD observed in BSC 6900 having BTS 3900 after.
The network was previously on e******* & it was swapped to huawei.

Traffic is same, but the drops have increased..can anyone help me in this regard...

[akmamit]

Hi,

There was poor MPD observed in BSC 6900 having BTS 3900 after.
The network was previously on e******* & it was swapped to huawei.

Traffic is same, but the drops have increased..can anyone help me in this regard...

[auto_art]

what are the drop reasons.?

[akmamit]

what are the drop reasons.?

the drop reasons are mainly T200 Expire & Radio Link failure

[auto_art]

if it is present in all BSC's. there might be some problem with parameter settings... what i am suspecting..

[akmamit]

parameter are mapped as per previous e******* settings....

[akmamit]

hi,

to add to the thread,..the network..previously had baseband hopping & after swap we implemented Rf hopping it....

the MPD was poor ..hence we reverted back to base band..hopping , still no improvement in MPD..

can anyone share some other possible causes influencing high call drop...after swap..from e*******

[Md.Moniruzzaman]

Can you segregate drop category (Signal Strength/Bad Quality/Sudden/Other/TA ??) Also direction (Uplink/Downlink ?) Because T200 times & Radio link failures indicate poor radio link between MS < ---- > BTS . If we want to draw conclusion about Hardware issue or other things let us answer the above questions.

[akmamit]

majority of the drops are due to signal strength & quality in the UL...any other information required, please let me know....

[Md.Moniruzzaman]

UL drop basically due to Planning issue. If earlier UL (SS & Bad Quality) drop was low comparatively. Through parameter check needs.