-
Member
Reputation: 30
E******* handover parameters for cell
UeMeasControl parameter group controls handover in RNC. However i only find this group of commands once so i think this parameters are the same for all cells. How can i do to change this parameters for one particular cell?? thanks a lot
-
2011-02-26 04:32 AM
# ADS
Circuit advertisement
-
Member
Reputation: 29
Re: E******* handover parameters for cell
Originally Posted by
Tomas Delgado
UeMeasControl parameter group controls handover in RNC. However i only find this group of commands once so i think this parameters are the same for all cells. How can i do to change this parameters for one particular cell?? thanks a lot
usedfreq2dRscp and usedfreq2dEcno
qqualmin and qexlevmin
-
Member
Reputation: 30
Re: E******* handover parameters for cell
Thanks mate, i found that ones in UtranCell, but lets say for example if i want to change event 1a threshold. I havent found this parameter for just one specific cell.
-
VIP Member
Reputation: 1849
Re: E******* handover parameters for cell
You cannot. These parameters are specified at the RNC level so cover all cells.
-
Member
Reputation: 29
Re: E******* handover parameters for cell
Originally Posted by
Tomas Delgado
Thanks mate, i found that ones in UtranCell, but lets say for example if i want to change event 1a threshold. I havent found this parameter for just one specific cell.
yes..these are RNC specific parameters you are looking for and cannot be changed for a cell to cell basis.
Bookmarks