-
Junior Member
Reputation: 12
RX quality very poor
hai friends,
Some sectors are showing very low RX quality app 30 % good samples only for all the TRx. these sectors are also showing dip in busy hour erlangs from 27 er to 12 er. but all other KPI s including TCH drop, hand over failure etc are with in bench mark. I have asked to check the hardware. what could be other issues?
-
2010-11-24 06:40 PM
# ADS
Circuit advertisement
-
Member
Reputation: 50
Re: RX quality very poor
How about the frequency ?
T_DR, HO, etc should be degraded from very bad RxQuality.
-
Junior Member
Reputation: 12
Re: RX quality very poor
Originally Posted by
Optimal
How about the frequency ?
T_DR, HO, etc should be degraded from very bad RxQuality.
Very Interestingly none of the other KPI have degraded.This is happening to more than 7 sectors. I have checked the BCCH frequency .But no clash is found.
-
Member
Reputation: 82
Re: RX quality very poor
what about the equipment
is it huawei or e******* before all.
because am specialised of huawei's equipment
-
Member
Reputation: 50
Re: RX quality very poor
Originally Posted by
kb.jayadev
Very Interestingly none of the other KPI have degraded.This is happening to more than 7 sectors. I have checked the BCCH frequency .But no clash is found.
When did the quality has been degraded?
Which vendor we looking for?
Can you try to deactivate frequency hopping and monitor quality for each TRX? It will show which TRX is the bad-quality.
-
Junior Member
Reputation: 12
Re: RX quality very poor
[QUOTE=Djemai;106911]what about the equipment
is it huawei or e******* before all.
because am specialised of huawei's equipment[/QUOTE
The vendor is NSN..and using siemens BTS
-
Member
Reputation: 37
Re: RX quality very poor
if u are getting bad quality in all the three sectors there will be definetly issue in hardware
-
Member
Reputation: 39
Re: RX quality very poor
do you have KPI called IOI i.e., interference on idle mode? if so, how does this IOI behaves during that time of rx_qual drop?
two issues i can predict from this:
1. Hardware: do you do radio calibration? or just try to replace radio
2. use Mapinfo to recheck frequency issues
-
Users Awaiting Email Confirmation
Reputation: 86
Re: RX quality very poor
Hi all,
Me also facing Rx Quality on some cells ,How i can check what is issue (System is Huawei) plz share ideas,No co adjacents is there and what more i check and how.
-
Member
Reputation: 37
Re: RX quality very poor
Originally Posted by
leelio
do you have KPI called IOI i.e., interference on idle mode? if so, how does this IOI behaves during that time of rx_qual drop?
two issues i can predict from this:
1. Hardware: do you do radio calibration? or just try to replace radio
2. use Mapinfo to recheck frequency issues
i think if u are using nsn then 196 report csn show you the reason
Bookmarks