If the low traffic cell is GSM, then are you using different bands in your network? This can be controlled by the Layer setting. The lower the layer the higher the priority and more subs will be forced onto this site therefore increasing the traffic. Is it a macrocell, microcell, pico or nano? Where is it situated, dense pop area? There could be another umbrella site taking all the traffic which can be shared by CLS if ericcson BSC. If 3G, you can increase CPICH power but then capacity is compromised. If no alarms on cell, then all you have to do is adjust these parameters to make the cell more attractive...increase ACCMIN, BSPWR and BSPWRB.
Cheers,
Byron
Check also cell load sharing, CLSLEVEL, CLSACC. Does your cell have MBCCHNO of the neighbouring cells?Pls, check it also.
In some cases in E******* RBSs there is problem on DRUs unit(RBS Type RBS2216,RBS2116)
The problem is in each unit there is 2 TRX and BCCH allocated to 1 TRX it is usually happening in networks this TRX output level will be weak then MS can not access to network(for your information there is no HW alarm in BSC) to understanding ask BSS to shift BCCH carrier to another DRU and then observe .
If traffic increased means your TRX is faulty!
check the geographical area and also check the other 2 sectors traffic.
Give it a Software Reset then analize the stats hourly if not fixed
Give it a Hardware Reset then analize the stats hourly if not solved
propably ..it needs Software upgrade so raise Trouble Ticket so RNC guys and BTS guys can upgrade their software keep analyzing the stats and it will be solved
Hi JUSTDREAM,
Before changing your software parameters, check first the hardwares..if not find anything wrong with your hardwares, collect stats, and compare it with your KPI...then proceed with software parameter change..
Regards//
Is it 2g/3g? Whats the vendor?
Bookmarks