I am also searching about antenna performance comparison between established vendors vs Chinese products
my requirement is on performance endurance after 2 to 3 years, and other aspects that has...
Type: Posts; User: srilasitha; Keyword(s):
I am also searching about antenna performance comparison between established vendors vs Chinese products
my requirement is on performance endurance after 2 to 3 years, and other aspects that has...
This is in SIM & not available in a DT trace, may be visible in qualcom signal trace
My question " Is this SIM timer can be change with an OTA upgrade"
For local roaming scenario (two PLMNs but with same MCC ) then home PLMN search according to SIM setting interval (6min to 30 min) in idle mode or 2 min after swtiched on
Do you have any reference on how to change Time T periodic search timer in local roaming with an OTA upgrade & any SIM requirement
Huawei 2G feature documentation for fast return to LTE
Use the IUB data throughput , after removing the signalling bw usage
If your A interface is TDM, most common place for mute calls is incorrect mapping of A interface circuits
issues in transcoder DSPs, BTS software issues,RX quality issues, Abis link issues, packet...
This can be due to Abis limitation or initial CS code setting
My logic is if the UE demands a higher throughput resource setup time should be same as latency.
I shared a latency evaluation doc published by Qualcomm
MOS is to measure what actually perceived by the customer. So impact in MOS affects to the sound that user can heard. you can refer wiki for MOS definition.
However small variations may not be...
Erlang concept is to identify the no of circuits needed. if you have multiple service each service MB has to be taken separately. if you mix it then there is no meaning of your Erlang figure ( only...
Does anyone suggest CEM tools
Isn't this same as the latency
Release 12 visions of
Huawei
ZTE
& NSN
Is it between same frequency or different frequency.
check whether the re-selection frequency configurations is different between vendors
Does that means third party reports containing E******* analysis will be removed too?
Why dont you forbids TD LTE re selection configuration in 3G
Is your cell is MBC with OL/UL configuration. if so check the sdcch configuration is only on UL or else check the configurations for OL immediate assignment parameters
Good suggestion. but I doubt whether this possible with few tools, with the changes on technology, features, UEs,etc.
May be with CEM , NMS, ERP you may able to drop down the numbers in the list.
Dear All,
Vendors vision on 3GPP release 12.
E*******
Alcatel
Qualcomm
Hi
Electrical tilt may be the best available option.
You can implement eICIC if the load is high.
Hi
Huawei highlighted following impacts in Co-LAC for 2G & 3G.
The 2G/3G Shared LAC feature has the following impacts on the system:
• When a subscriber roams between the BSC and the RNC in...
Has anyone found PCHR analyzer tool for RAN15
Thanks for sharing the equation,seems useful for initial calculation
Maximum Power assigned for the channels depends on spreading factor. Power control is used to reduce the interference to outer cells. you can observe Ec/Io changes to identify interference increments...