You can use 5G ANR Feature
BR//
Type: Posts; User: Shakeel_15; Keyword(s):
You can use 5G ANR Feature
BR//
VSWR test gives you idea.
Your case need cable tracing at site.
BR//
U can run VSWR test in U2020
Also right click on required site in main topology and see device management
BR//
Massive mimo calculation is bit different.
First clarify yourself FDD OR TDD, ntnr??
Finally keep in cosideration the total power of AAU.
Try to design the RS power based on the total power...
Hello,
It might happen at MME Boundaries if no pooling. Check in per NBR Stats which Neighbor relations are contributing.
It can be possible because of MME Pool configuration issue OR missing...
If There is no MSG 2 then for sure there will be no message 3 means Sleeping Cell...... No Comparison between MSG 1 and other later messages
BR
MSG-1 RACH Preamble
MSG-2 RAR
MSG-3 RRC Conn Req
BR,
Hello,
Sleeping Cell : If MSG-1>500 & MSG-2 OR MSG-3 =0 then it is sleeping cell
BR
Hello,
try also http://www.mapperg.com
BR,
First Check External definitions like TAC,PCI,ARFCN etc should be ok
Secondly check the no SCTP links of problemtic site and enighbors
Also S1 Interface count should also be same on problematic...
Hello,
Could you give some more details of the problem? Statistics etc?
BR
Hello
By using MapInfo Thematic Map Option. Generate thematic via grid selection
BR
Hello,
Better to set RBG allocation strategy to adaptive.
It will be useful according to the PRB demand and adaptively change the strategy considering the PRB and throughput.
BR
Hello,
Try to use ISSTAR in U2000. But you should know python for the scripts of ISSTAR.
BR
Hello,
MCS depends on CQI (Channel Quality Index) and CQI depends on SINR.
You first need to check the radio conditions Coverage, SINR etc
Check distribution porpotion or Average CQI.
In...
Hello,
Many steps involved in Throughput Troubleshooting.
First test with different devices as well means check with dongles and handset.
Check backhaul txn at ETHPORT
CHECK by uploading...
Hello,
In LTE its name is Interferenceavg and it should not be greater than -102 in worst case.
the normal values are -118/-117
BR
Hello,
-106 to -102 are normal values.
above -100 are not good and also below -108.
BR
Hello,
As far as i know
UMPT is main tranmission card while UTRP is for expansion means you can connect more than one UMPT Card through UTRP board.
You have limited slots in BBU i guess from...
Hello,
For 3G,
RF Unit Maintainance link failure
RF Unit VSWR Threshold crossed
UMTS Cell unavailable
UMTS Cell setup failed
Board Hardware fault
Board not in position
Local Cell capability...
MML UCELLDRD
Parameter ldbdrdswitchdch
& ldbdrdswitchhsdpa
BR
Hello,
Voronoi Mapbasic tool builtin in MapInfo.
br
Same on win 7.
BR
Hello nickolay,
there is no batch file startserver.bat in the attachment.
BR
Hello,
For Huawei it depends upon the specification of LBBP Boards.
BR