Hi,
Could you share V100R100C02_01 document on ATS9900 - IMS/TAS
Thanks
Type: Posts; User: Rifa; Keyword(s):
Hi,
Could you share V100R100C02_01 document on ATS9900 - IMS/TAS
Thanks
Hi,
I'm looking for the V100R100C02_01 document on ATS9900, which describes the IMS/TAS.
Hope someone could share.
Thanks in advance
Regrads
Hi,
In our customer network we have Nokia eNodeB and Huawei MME. Lately we are observing lots of error 87 from MME. This error 87 - UE not responding, kind of causing panic to our customer. Would...
Hi,
Could someone share the detail on the Backhaul solution from E******* for Small Cell, called BALL. See attached slide#18
I'm looking for the specification and deployment requirements....
Thank you. Is there any tool available to calculate required backhaul BW.
Hi,
Could someone explain how does the backhaul BW configuration affect the NodB throughput. Is there any calculation how to map the NodeB throughput to alocated Iub BW.
Ecample if I enabled 9Cell...
Did you try to do the PIM test on the affected sites using the PIM tester?
The tool should help you if there was anything wrong Antenna FL.
If you need to confirm external interference use the...
Thank you.
By the way what is the timer that controls the Iu release in the UGW, during intersystem change or the RAU between different RNC?
There was no SRNS context exchanged between CN & RNC,...
Hi,
I'm looking for documents on UGW9811, appreciate someone could share.
Looking for document related to;
Technical description
Configuration
Parameters/Timers
As I'm trying to trouble...
Hi Guru's,
What are the supported WB-AMR codecs in NSN RNC?
I understand we are only capable to equip WB-AMR 12.65. Do we allow support for other higher codec as below specified by 3GPP.
Do we...
Hi,
In E******* solution how do we find the info about ;
SAIC capable MS penetration and VAMOS capable penetration MS.
Is the VAMOS feature in E******* contribute to failure in drop related to...
Hi,
Could someone explain, what is the impact of DRX cycle length parameter, if it is not defined correctly between S4-SGSN & RNC.
What is the parameter name in SGSN?
Our customer using Nokia...
Hi guru's,
I'm looking for some detail on eMLPP feature and hope someone could help me. I'm looking for the following;
1) technical description on both BSC & RNC
2)Related parameters
3) Test...
Hi,
In our network where we have NSN RNC & Huawei PS core.
Recently intergared NSN RNC into new ATCA based USN SGSN and found the nodeB in RNC suffering with HSDPA & HSUPA retainability.
I'm...
Hi, Does anyone have experience in deploying multipoint A between NSN BSC/RNC with E******* MSC. Appreciate if you could share if any issue expereienced. Also would like to understand what would be...
Thank you. I have checked 3GPP 32407 section4.1.2.10, and it says it is due to CN.
Calling party releasing the call after alerting: On transmission of "DISCONNECT"(cause #16 "normal call...
Hi,
I would like to know on which spec I could find info for reasons for CN sending DISCONNECT message during call setup. From the MEGAMON trace we noticed that after alert message, RNC received a...
Hi,
Yes we had BBH before SFH implemented. We also retuned BCCH and no impact on BCCH. The impact is only noticed on TCH
What mean by "concider azimuth with respect to MAIO assignment" appreciate...
Appreciate if you could point me to specific parameter related to the quality thrshold
Thank you
We are using 1X1 network wide with 63 HSN. MAIO step - 2.
What information that we could get out of reason of drop in relation to SFH.
Thanks
Hi, Appreciate if someone could share some info on SFH(RF Hopping) implementation and the description on how the SFH works in NSN. We noticed after SFH implementation the DCR increased.
Thank you,
Hi,
Thank you so much. By the way the NSN is on RU30. Also based on the comment that we had highlighted to Huawei on the state transition, they had updated the SW in E355 and last Friday we verified...
We only have problem with E355 dongle. By the way NSn had traced and claim the E355 is not able to trasition from CELL_DCH to CELL_PCH, when there is no data activity. Is there any specific feature...
Hi, Thanks again.
The RAN is from NSN.
We tried with ZTE dongle as well(BB+WiFi) and no problem.
Also no problem of android/smart phones doing the data transfer at the same time at the same...
Hi,
Thank you.
I have tried to deactivate then reactivate PDP. It is ok for a while but after a while same problem appear again. I have also captured the NetMon logs while using the dongle E355 and...