Dear Friends ,
Could you pls share the benchmark values for below parameters.
Avg. Latency in radio network
Avg. Latency of total path (ISP Server to handset)
Thanks
Type: Posts; User: 070057r; Keyword(s):
Dear Friends ,
Could you pls share the benchmark values for below parameters.
Avg. Latency in radio network
Avg. Latency of total path (ISP Server to handset)
Thanks
thanks . We have implemented and didn't get any complaint regarding that.
Sorry. I want to know, when the phone is doing reestablishing due to poor quality (radio link failure) , will that create mute calls?
Because normally call will be dropped after RLT expires but here...
thanks friend. Do you know that creates call clarity and mute situations without dropping call.
Dear Friends,Can some one explain the pros and cons of H****** call reestablishment feature?BR,Chandimal
Hi Guys,
I want to know any one use Samsung S8 (Qualcomm chipset) with Nemo Handy license.
Thanks in advance
Hi,
Please kind enough to send the password for below key
2084042652055618414528610704_V:5.3.0.0
Dear Experts,
Is there any special configuration required when defining L850 Cells. We defined a test cell but can't select the Cell while in DT/field. Mobile phone support L850 Band5. Please help...
Thanks RF Enginner, But we are already configured those values...what do you think about 2G to 3G handovers, we are going to enable that.Is it good or bad?
Dear Friends,
We want to offload GSM 900 traffic to 3G and DCS. Could someone please suggest some features . We have both huawei and ZTE networks.
BR,
Hi Guys,
In our network there are some complaints about cross talk . Can it be due to the same BCCH and BSIC of near by sites.
Dear Friends,
Can't we lock more than one GSM ARFCN in nemo outdoor or handy?
thanks
Dear All,
We are using nemo Invex II for benchmarking. but sometimes devices are not connecting to UICs. Anybody face these situations? what can we do to overcome this issue.
Dear All,
Could some please help me to create customized reports in Nemo Analyze??
thanks,
Dear Experts,
Could you please share details about high gain antennas.
thanks a lot
Hi babak1349,
thanks for helping. the answers will be
1. Yes DTM enabled
2.Yes multi RAB established,as much user in 3G mode both CS ans PS is working, IRAT happen due to the radio condition,...
Dear Friends,
Can you at least mention that do u have this kind of problem in your networks ?
Dear Experts,
We have an issue in our network as follows.
A user in 3G, starts a data session, and he receive a call. Depending on RF status IRAT handover is triggered and only CS is transferred...
It was a customer complaint we found this. need to check few locations since this is the first time I saw such a thing...
Dear Friends,
There is a voice quality issue when the user in 3G but only two cells are in active set. When the RSCP power difference is less SQI is getting low. Any one experienced such a...
Hi,
Any one tested Inter layer HO in Huawei GSM networks? Is it working as it describes?
Dear Experts,
I want to know whether following Tabs have TEMS, Nemo pocket versions. Can somebody pls reply quickly
Tab S2
Tab S
Tab E9.6
Tab 4_10
Dear Experts,
we have a serious issue in our 2G IBS. Whatever ever the frequency we used the adjacent frequencies are amplified too. Can someone experience such incident or know the issue reply...
Thanks hoanan,
This by using spider graph right? But here there are all the serving cells. Is there any method to get the each neighbor's coverage alone? . I mean the rx levels of best NR , rx...
Dear Friends,
Please help me in this matter. What I want to know if there is a method to get the 4th strongest neighbor in GSM using TEMS discovery. Also it should be able to show in a map...