Hi Dears,
I Need DBS3900 RRU3278 GSM/LTE Hardware User manual. Can anyone help please?
Type: Posts; User: fdanaei; Keyword(s):
Hi Dears,
I Need DBS3900 RRU3278 GSM/LTE Hardware User manual. Can anyone help please?
Hi dears,
How we can find "Routing area color code" parameter value, in NOKIA BSC?
(standard 44.018 Table 10.5.2.34.1 ; < RA COLOUR : bit (3) >).
I can't find it in NED or system dump.
Hi dear,Yes, I have installed it in win8 64bit, be sure. Base on the image It seems that you could run bcdedit command successfully. Try to repeat steps 3-7 again. you can use dseo13b for...
Hi dear, ATOLL 3.3.1 works in Win8.1 x64 but usually (because security) there is some difference with win7 related steps:
- Instead of doing dseo13b step for activating test mode do following...
Hi, problem solved, Thanks
Hi, I tested the license in Actix in Two ver. (318.947 & 316.496) and Copied lservrc in any places (Bin folders in ProgramData/Actix/... and Program files/Actix/..) but following message appear when...
Hi Dear Maysam
Thank you for the attention,
My PC Selector: 0x14
New Style : *1CX KPDF M73W VCK3
Email: fdanai75@gmail.com
Regards (I will add Rep. right Now)
Hi friends, ATOLL 3.3.1 works in Win8.1 x64 but usually (because security) there is some difference with win7 related steps:
- Instead of doing dseo13b step for activating test mode do following ...
Hi dear Friend,
For WCDMA (after Rel.4) in HSDPA and HSUPA you can refer to page 19&20 of attached file.
As we know, in DL (HSDPA) SF of every code is fix (equal 16).
For WCDMA Rel.99, wolverine's...
Hi dear friend and sorry for late answer,
Related cell has following noticeable info:
TCH Erlang=10,
SDCCH Erlang=10,
LAC border Cell,
RxLevAccMin=-109dBm
It seems because location update,...
Hi dear friend, we need some info related to you issue:
1- How many TRX are there in the cell also how many available time slot?
2- Dual or single band cell?
3- Busy hour erlang of cell?
4- How...
Hi dear hoangtuna and mahbub,
It is a part of this book:
"Advanced Cellular Network Planning and Optimisation: 2G2.5G3G...Evolution to 4G 2007, Ajay R. Mishra" and you can get it from following...
Hi again dear engineer, my idea about BCCH frequency was only for control of overshooting sites in the location, because you have only 12 hopping frequency. These numbers of frequencies are finished...
Hi dear friend, Based on your attached picture, BCCH signal level in that location is low (-84dBm). I think your problem is related to lack of dominant cell.
Do following steps (If you sure about...
Hi dear friend, the answer is related to GSM and WCDMA (3G) standards in idle mode. In GSM standard, only signal level has been considered for cell selection and reselection (and related C1 and C2...
TI 16.1.1 related Drivers Link:
http://www.4shared.com/get/B_fjQobFce/TEMS_Investigation_1611_Driver.html
for Xperia V (LT25i) driver refer to page 38 and 39 in the manual (I tested it,it is easy)....
Hi, I am not sure that I have Understanded your mean but I have some information about Worst and Best Pair HSN. I have attached all of these info in following Link.
Worst and Best HSN Pairs.pdf -...
Hi, I think friends said main reasons for handover failure. But dont forget to check same BCCH+BSIC Problem. also existence of faulty TRX in Target Cell.
ok thanks a lot for all of your kindness.
I dont know too why we need to do this actions.
Hi, I Hope to help others in this site.
this site is the best in wireless comm. info.
welcome to this forum my friend.
it is useful book.
Hi,
I am here for give and get info.
Thanks
It was good