PDA

View Full Version : Problem with Pathloss 4.0 - MW Radio Lookup Tables



ipax
2010-03-13, 12:05 AM
Hello,

I noticed small issue regarding MW Radio Lookup Tables in Pathloss 4.0.
Its like this:

- I create MW Radio Lookup Table by selecting several radio models (MW Radio Lookup Table -> Code Index)
- Parameters in MW Radio Lookup Tables can be modified.
- I change value of BER 10-3 RX Treshold parameter in Radio Lookup Table.
- This change is visible and permanent in Radio Lookup Table, and i choose this radio model for both sites
- in Worksheet -> Radio Equipment change to BER 10-3 RX Treshold is immediately visible, but if i close and reopen pathloss file then BER 10-3 RX Treshold is changed to original value
- I noticed that from all parameters available in Radio Lookup Table, only BER 10-3 RX Treshold value is reseting to original value.

My question is:
- Why is this reseting of BER 10-3 RX Treshold happening?
- Is is possible somehow to keep custom value of BER 10-3 RX Treshold after i close pathloss file.

Hope someone can help me with this :)

junaid.ali63
2010-03-13, 07:37 PM
I didnt notice that. I will check and then tell you. However have you performed inteference calculation. I am facing a problem while doing that