PDA

View Full Version : Aircom Macrocell propagation model parameters



m_afrasiabi
2009-12-20, 05:31 PM
Dear All,

I want to tune Marcocell model parameters for 450MHz and in rural areas.

In the Asset Reference manual stated that the presented parameters for 450MHz band is based on the urban areas. How could I change the parameters to be applicable for Rural Area

Waiting for you kind responses.

BY

j.afshar
2010-04-25, 06:18 PM
Hi Dear

inasmuch as i know, i doesn't cause big difference, because you are going to tune your model and the mentioned value in the enterprise are just as a defualt parameters. you can set these parameters as rudimentary values and keeping on your tunning.
on the other side, you should repeat the tunning process several times after applying achievement parameters to Propagation model at the end of each stage.
cheers

angelpy
2010-04-26, 09:25 PM
Hi friend!


The parameters for model predictions is a standard of Aircom, for tunning theses parameters, you must make measurements in field with the frequency band selected.

The results of these measurements enter them in the Asset for tunning the model.
Check in the forum, how can enter this results.
See Propagation Model Tunning.

Br
Angelpy