nabil el haddani
2014-07-09, 12:51 AM
Hi Guys,
What values do you recommend for ServiceOffset2dEcNo and RSCP for PS and mRAB (Assuming that 2dThreshold Ecno is set at -13/-14 and RSCP at -105). Personally I am advising to start compressed mode maximum at -16 or -108 for CS+PS mRAB (later there is a CS drop risk and even if CS call ends on éG we may reselect 3G again) and to disable completely compressed mode for PS (set service offset to very low value), based on the fact that CM halves almost the throughput and also 3G performance in very bad conditions are still better than very good EDGE.
What do you think?
Cheers
What values do you recommend for ServiceOffset2dEcNo and RSCP for PS and mRAB (Assuming that 2dThreshold Ecno is set at -13/-14 and RSCP at -105). Personally I am advising to start compressed mode maximum at -16 or -108 for CS+PS mRAB (later there is a CS drop risk and even if CS call ends on éG we may reselect 3G again) and to disable completely compressed mode for PS (set service offset to very low value), based on the fact that CM halves almost the throughput and also 3G performance in very bad conditions are still better than very good EDGE.
What do you think?
Cheers