PDA

View Full Version : KPI reports



justdream
2009-01-27, 05:51 PM
Guys,
how could I generate reports using TEMS investigation or route analysis showing the following:
Site KPIs (DCR, OCSSR, HO Causes)

and what's the meaning of DCR and OCSSR?

Please advice me ASAP, all times I'm in hurry :D

justdream
2009-01-28, 03:36 AM
sorry, I wrote wrong answer but I don't find a way to delete it

tibetan
2009-01-28, 04:04 AM
Guys,
how could I generate reports using TEMS investigation or route analysis showing the following:
Site KPIs (DCR, OCSSR, HO Causes)

and what's the meaning of DCR and OCSSR?

Please advice me ASAP, all times I'm in hurry :D

DCR: Dropped Call Rate
OCSSR: (Originating ?) Call Setup Success Rate

venom
2009-01-28, 04:26 AM
Some Important KPIs are below:

DCR = Drop Call Rate.
CSSR/CSR = Call Setup Success Rate.
HOSR/HSR = Handover/Handoff Success Rate
MPD = Minutes Per Drop.
HI = Health Index
Erl/Trx = Traffic Erlang Per TRX

Why are u considering KPIs through a drive test measurement? It is always calculated from Statistics, Why? Because Statistics gives a realistic image rather than drive test data.

Drive Test measurements are used for troubleshooting, not to monitor anything. TEMS and ACTIX or any other Post Processing tool has different formulae of calculating the CSSR and DCR. Whereas when you calculate it from statistics then you have to consider the counters in which drop calls are reported and then generate a formula for it.

justdream
2009-01-28, 04:29 AM
Thanks a lot,

regarding


Why are u considering KPIs through a drive test measurement?
The customer who need it by this way not me

justdream
2010-12-01, 09:20 PM
Some Important KPIs are below:

DCR = Drop Call Rate.
CSSR/CSR = Call Setup Success Rate.
HOSR/HSR = Handover/Handoff Success Rate
MPD = Minutes Per Drop.
HI = Health Index
Erl/Trx = Traffic Erlang Per TRX

Why are u considering KPIs through a drive test measurement? It is always calculated from Statistics, Why? Because Statistics gives a realistic image rather than drive test data.

Drive Test measurements are used for troubleshooting, not to monitor anything. TEMS and ACTIX or any other Post Processing tool has different formulae of calculating the CSSR and DCR. Whereas when you calculate it from statistics then you have to consider the counters in which drop calls are reported and then generate a formula for it.

Dear Friend, can you please tell me about MPD (minutes oer drop)?
I's like to understand it, this is new KPI or me

salamanda1969
2010-12-01, 09:46 PM
Min per drop = ( cell Erlang x 60 ) / Num of drops
(minute / drops)

cesimkaol
2010-12-01, 09:48 PM
May you explain that how can we reach statics?from where or via which tool?

justdream
2010-12-01, 09:49 PM
Min per drop = ( cell Erlang x 60 ) / Num of drops
(minute / drops)
sorry I didn't get you..
Can you please explain in more details

Thanks

justdream
2010-12-02, 10:31 PM
I've found this explannation over internet:
EMD (Erlang Minute per Drop Definition: Total of Erlang minutes (TCH occupation) in one period measurement per drop call (after TCH Assignment)

ok, I got it but what's the importanc eof this indicator?? I still see it not important (kindly share your opinion)?